Advertisement
Quick Links
RLN4780
Remote Mount Kit
(excluding Cable Kit)
Professional Radio
Remote Mount Controlhead Installation
Lh
CAUTION: The radio must be disconnected from the power supply before
commencing any disassembly.
For installation in environments where water or dust are present, the
Remote Mount must be mounted with the speaker grill facing down.
The Installation Manual should be referred to for more detailed information
on warnings and safety.
To Disassemble the Radio from the Control head
1.
Remove the Controlhead from the Transceiver by inserting the dismantling tool in the
recess between the Controlhead and the Transceiver.
2.
Split the Controlhead into Front and Back housings by inserting the dismantling tool in
the recess between them.
NOTE
1.
To minimise cosmetic damage disassemble from the bottom side, (label side)
.
2.
The flex and Controlhead Back Housing are not required for remote mounting.
3.
Remove the flex
.
To Assemble
the
Remote Front Housing:
1.
C.onnect the flex from
th.e
Remote Front Housi[1g to the top small
con.nector
in the
Transceiver.
NOTE
For
correct orientation of the flex in the
Transceiver,
the
"plastic"
tab should be
up,
contacts facing down
.
Align the '0' on the flex with the '0
'
on the
Transceiver.
The
flex must be pushed into the connector until it meets the
stop.
2.
Press the Remote Front Housing onto the Transceiver chassis until the 4 chassis tabs
snap into
place.
To Assemble the Remote Back Housing
1.
Connect the flex from the Remote Back PCB to the
Controlhead.
NOTE
For ·correct orientation of the flex, align the '0' on the flex with the '0' on the
PCB.
2.
Orientate the Controlhead in the Back
Housing,
to suit the mounting position
.
3.
Press the Controlhead onto the Remote Back Housing until
ALL
tabs snap into
place.
Advertisement
