Table of Contents
Advertisement
Connect to the Management Ethernet Port
RJ-45 Pin
4
5
6
7
8
Connect to the Management Ethernet Port
The management Ethernet port provides out-of-band management, which enables you to use the command-line
interface (CLI) to manage the router by its IP address. This port uses a 10/100/1000 Ethernet connection with
an RJ-45 interface.
To prevent an IP address conflict, do not connect the management Ethernet port until the initial configuration
Note
is complete.
To connect cables to the system management port, attach Category 5 cables directly to the RJ-45 receptacle
on the management Ethernet port.
1
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
38
Management Ethernet port
Connect Router to the Network
Signal
Ground (GND)
GND
Rx
—
—
2
Console port
Advertisement
Chapters
Table of Contents
