Table of Contents
Advertisement
About the Access Point
• FlexConnect mode: In FlexConnect mode, the data traffic is switched locally and is not sent to the
• Monitor mode: In this mode, specified Cisco APs can exclude themselves from handling data traffic
• Sniffer mode: In this mode, the AP starts sniffing the air on a given channel. It captures and forwards
Note
• Site Survey mode: The AP GUI is enabled and is used for configuring the RF parameters for site survey
AP Model Numbers and Regulatory Domains
AP Type
Access Point for indoor
environments, with internal
antennas
Verify whether the AP model you have is approved for use in your country. To verify approval and to identify
the regulatory domain that corresponds to a particular country, see
wireless/wireless-compliance-tool/index.html. Not all regulatory domains have been approved. As and when
they are approved, this compliance list is updated.
Note
controller. In this mode, the AP behaves like an autonomous AP, but is managed by the controller. Here,
the AP can continue to function even if connection to the controller is lost.
between clients and the infrastructure. These APs act as dedicated sensors for location-based services
(LBS), rogue AP detection, and intrusion detection system (IDS).When APs are in monitor mode, they
actively monitor the airwaves and typically, do not serve clients.
all the packets from the clients on that channel to a remote machine that runs AiroPeek NX or Wireshark
(packet analyzers for IEEE 802.11 wireless LANs). This includes information on timestamp, signal
strength, packet size, and so on.
In the sniffer mode, the server to which the data is sent should be on the
same VLAN as the wireless controller management VLAN. Otherwise, an
error message is displayed.
investigation. For information, see the
Series Wireless Controller Software Configuration Guide.
The x in the model numbers represents the regulatory domain.
Cisco Catalyst 9164 Series Wi-Fi 6E Access Point Hardware Installation Guide
Access Points Survey Mode
Product ID
CW9164I-A
CW9164I-B
CW9164I-E
CW9164I-F
CW9164I-Q
CW9164I-R
CW9164I-Z
CW9164I-ROW
CW9164I-MR
AP Model Numbers and Regulatory Domains
section in the Cisco Catalyst 9800
Details
Wi-Fi 6E AP, tri-band, 802.11ax
with internal antennas
https://www.cisco.com/c/dam/assets/prod/
3
Advertisement
Table of Contents
Troubleshooting
