Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Husqvarna Fleet Services
- Page 1 ™ Husqvarna Fleet Services Machine Sensor Operator's manual 2-10...
-
Page 2: Table Of Contents
Husqvarna Fleet Gateway app. Support The uploaded data shows the last known location of the product, operation statistics and servicing history. For support about the product, speak to your Husqvarna servicing dealer. 2132 - 001 - 19.10.2023... - Page 3 Product overview 1. Sensor top cover This product complies with the applicable 2. Sensor circuit EU Directives. 3. Battery 4. Foam gasket 5. Rivet 6. Sensor bottom cover This product complies with the applicable 7. Adhesive tape UK Directives. 8. Maintenance tool 9.
-
Page 4: Safety
™ 2. Download the Husqvarna Fleet Services app or is enabled on your mobile device. the Husqvarna Fleet Gateway app on your mobile device. ™ 2. Open the Husqvarna Fleet Services app or the Husqvarna Fleet Gateway app on your mobile 3. - Page 5 ™ Services Machine Sensor on a field. Make sure that the LED indicator on the sensor product circuit flashes one time each second. 1. Examine where to install the Husqvarna Fleet ™ To examine Services Machine Sensor. Refer to ™...
-
Page 6: Operation
Note: Husqvarna recommends you to attach a decal on the product with the name of the product. This makes it easier to identify the product in the Husqvarna Fleet ™ Services app or the Husqvarna Fleet Gateway app. -
Page 7: Maintenance
The sensor has found the engine/motor of the product and the configura- for 5 seconds and comes on again. tion is set. Operation of the product • The data update shows in the Husqvarna Fleet ™ Services app approximately 15 minutes after the ™... - Page 8 2. Remove the sensor circuit from the sensor bottom 7. Put the sensor circuit with the foam gasket into the cover. sensor bottom cover. 3. Remove the battery from the sensor circuit and 8. Use the point of the maintenance tool to carefully recycle it.
-
Page 9: Troubleshooting
Troubleshooting Troubleshooting ™ If the Husqvarna Fleet Services Machine Sensor does not operate as usual, follow the table below. Speak to your Husqvarna servicing dealer if you cannot find the cause of the fault. Symptom Cause Solution ™ The LED of the Husqvarna The light is too low for the light sensor. -
Page 10: Technical Data
• The product and battery are not domestic waste. For more information, speak to your Husqvarna dealer. Technical data Technical data ™ Husqvarna Fleet Services Machine Sensor Modulation Nominal input V Max. input V Min. input V Internal operation maximum temperature °C/°F 55/131 Internal operation minimum temperature °C/°F... - Page 11 2132 - 001 - 19.10.2023...
- Page 12 Original instructions 1141823-26 2023-10-19...