Epson Small-in-One XP-330, XP-430, XP-434 - All-In-Ones Printer Installation Guide Manual

Also See for Small-in-One XP-330:

Start here (4 pages)

Quick manual (5 pages)

Table of Contents

Contents

1 Unpack
2 Turn on and configure
3 Install ink cartridges
4 Load paper
5 Install software
- 5.1 Wireless connection
- 5.2 Direct USB connection
6 Mobile printing
7 Any problems?
8 Any questions?
- 8.1 Technical support
9 Need paper and ink?
10 Documents / Resources
- 10.1 References
- 10.2 Download manual

Epson Small-in-One XP-330, XP-430, XP-434 - All-In-Ones Printer Installation Guide Manual

Unpack

warning Note: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.

Unpack

Turn on and configure

Step 1
Turn on and configure - Step 1

Do not connect to your computer yet.

Step 2
Turn on and configure - Step 2

Do not lower the control panel without first squeezing the release bar underneath or you may damage the product.

Step 3

To select English as your language, press OK.

If you want to change the language, press or to select it, then press OK.

warning Note: You can change the language later using the product's control panel.

Install ink cartridges

Step 1
Install ink cartridges - Step 1

Step 2
Install ink cartridges - Step 2

Step 3
Install ink cartridges - Step 3

Step 4
Install ink cartridges - Step 4

Step 5
Install ink cartridges - Step 5

Press to prime the ink delivery system. Priming takes about 4 minutes.

warning Note:

The printer is designed for use with Epson ® cartridges only, not third-party cartridges or ink.
The cartridges included with the printer are designed for printer setup and not for resale. After some ink is used for priming, the rest is available for printing.

Don't turn off the printer while it is priming or you'll waste ink.

Load paper

Step 1
Load paper - Step 1

Step 2
Load paper - Step 2

Step 3
Load paper - Step 3

Step 4
Load paper - Step 4

Step 5
Check the current paper settings on the control panel.
To use these settings, press OK. If you want to change the settings, press or to select Change, then press OK. Select paper size, press OK, select paper type, then press OK to confirm settings.

Install software

warning Note: If your computer does not have a CD/DVD drive or you are using a Mac, an Internet connection is required to obtain the printer software.

Make sure the printer is NOT CONNECTED to your computer.
Windows^®: If you see a Found New Hardware screen, click Cancel and disconnect the USB cable.
Insert the product CD or download and run your product's software package:
XP-330: www.epson.com/support/xp330downloads (U.S.)
or www.epson.ca/support/xp330downloads (Canada)

XP-430: www.epson.com/support/xp430downloads (U.S.)
or www.epson.ca/support/xp430downloads (Canada)

XP-434: www.epson.com/support/xp434downloads (U.S.)
or www.epson.ca/support/xp434downloads (Canada)
Follow the instructions on the screen to run the setup program.
OS X: Make sure you install Software Updater to receive firmware and software updates for your product.
When you see the Select Your Connection screen, select one of the following:

Wireless connection

In most cases, the software installer automatically attempts to set up your wireless connection. If setup is unsuccessful, you may need to enter your network name (SSID) and password.

Direct USB connection

Make sure you have a USB cable (not included).

Mobile printing

Epson Connect™ allows you to connect wirelessly from your tablet, smartphone, or computer and print documents or photos from across the room or around the world.

Set up your product for a wireless connection as described on this sheet, then see your Quick Guide or visit www.epson.com/connect for information on different printing solutions available for your mobile device.

Any problems?

If you experience problems during setup, see below:

Network setup was unsuccessful.

Make sure you select the right network name (SSID). The printer can only connect to a network that supports 2.4 GHz.
If you see a firewall alert message, click Unblock or Allow to let setup continue.
If your network has security enabled, make sure you enter your network password (WEP key or WPA passphrase) correctly. Passwords must be entered in the correct case.

Setup is unable to find my printer after connecting it with a USB cable.
Make sure the printer is turned on and that it is securely connected as shown:
Make sure the printer is connected as shown

Any questions?

Technical support

www.epson.com/support (U.S.) or www.epson.ca/support (Canada)
(562) 276-4382 (U.S.) or (905) 709-3839 (Canada), 6 am to 8 pm, Pacific Time, Monday through Friday, and 7 am to 4 pm, Pacific Time, Saturday. Days and hours of support are subject to change without notice. Toll or long distance charges may apply.

Need paper and ink?

Try Epson specialty papers with DURABrite^® Ultra Ink for professional results. You can purchase them at www.epson.com/ink3 (U.S. sales) or www.epson.ca (Canadian sales). You can also purchase supplies from an Epson authorized reseller. Call 800-GO-EPSON (800-463-7766).