Table of Contents
Advertisement
Enter the protected menus in the InfoCenter to change
the acceleration mode. The acceleration mode has
the following 3 positions:
•
Low—least aggressive acceleration and
deceleration
•
Medium (default)—medium acceleration and
deceleration
•
High—most aggressive acceleration and
deceleration
Understanding the
Warm-Up Mode
When starting the machine in cold weather, warm-up
mode limits the engine speed to low idle for a short
period after the engine is started, preventing potential
component damage from operating the machine with
cold oil.
A snowflake icon
denotes when warm-up mode is active. Do not
operate the machine until after the warm-up period.
Understanding Toro Smart
Power™
With Smart Power, the operator does not have to
listen to the engine speed in heavy load conditions.
Smart Power prevents the engine from bogging
down in heavy cutting conditions by automatically
controlling the machine speed and optimizing cutting
performance.
Note:
By default, the Smart Power feature is O
Starting the Engine
Important:
The fuel system automatically bleeds
itself before starting the engine if you are starting
the engine for the first time, the engine has shut
off due to lack of fuel, or you have performed
maintenance on the fuel system.
1.
Sit on the seat, keep your foot off the traction
pedal so that it is in N
parking brake, and ensure that the PTO switch
is not engaged.
2.
Turn the key to the O
An automatic timer controls the glow plug
preheat for 6 seconds.
3.
After preheating the glow plugs, turn the key to
the S
position.
TART
Crank the engine for no longer than 15 seconds.
Release the key when the engine starts. If
on the InfoCenter screen
, engage the
EUTRAL
/P
position.
N
REHEAT
additional preheating is required, turn the key to
the O
FF
position. Repeat this process as required.
4.
Run the engine at low idle speed until it warms
up.
Shutting Off the Engine
1.
Move all controls to N
parking brake, and allow the engine to reach low
idle speed.
2.
Turn the key to the O
from the switch.
Cutting Grass with the
Machine
1.
Disengage the parking brake, disengage the
PTO, and raise the cutting units.
2.
Drive the machine to the mowing area.
3.
Park the machine approximately 6 m (20 ft)
off the fairway, facing the intended mowing
direction.
4.
Lower the cutting units completely with the
lift/lower control lever.
5.
Engage the PTO.
Note:
Note:
high idle when you lower the cutting units and
activate the PTO switch.
6.
Tap the lift/lower control lever rearward to lift the
.
N
cutting units to the turnaround position.
Note:
without holding it raises the cutting units to the
turnaround position and stops the rotation of the
reels until the cutting units are lowered.
7.
Using the traction pedal, approach the mowing
area slowly.
8.
Once you reach the edge of the mowing area
to start mowing, lower the cutting units with the
lift/lower control lever.
Note:
not lower early or mow an unintended area.
9.
Complete the mowing pass.
10.
When nearing the opposite edge of the fairway
(prior to reaching the edge of the mowing area),
tap the lift/lower control lever rearward to lift the
cutting units to the turnaround position.
11.
Perform a tear-shaped turn to quickly line up for
your next pass.
37
position and then to the O
EUTRAL
position and remove it
FF
The cutting units will not start.
The engine speed automatically rises to
Tapping the lift/lower control lever
Practice to ensure the cutting units do
/P
N
REHEAT
, engage the
Advertisement
Table of Contents
