Table of Contents
Advertisement
8. Install the brake spring onto the idler arm
9. Install the drive belt cover with the bolts that you
removed in step 1.
Note: Ensure that the drive belt is properly adjusted
and operating; refer to
(page 12)
and
Adjusting the Control Cable (page
Adjusting the Quick Shoot
Control
If there is more than 13 mm (1/2 inch) of slack in the Quick
Shoot cable
(Figure
38) or the discharge chute does not rotate
left and right in equal angles, adjust the Quick Shoot control
cables.
1. 13 mm (1/2 inch) maximum slack
1. Loosen the 2 Quick Shoot control-cable clamps
39).
1. Cable clamps
2. Position the Quick Shoot control between the 2 arrows
located on the right side of the upper handle
40).
(Figure
Checking the Control Cable
Figure 38
Figure 39
37).
13).
1. Arrows
3. Rotate the discharge chute so that it faces straight
ahead and the arrow on the back of the discharge chute
aligns with the arrow on the shroud
(Figure
(Figure
17
Figure 40
(Figure
Figure 41
41).
Advertisement
Table of Contents
