Premaintenance Procedures; Raising The Seat; Accessing The Battery; Lubrication - Toro TimeCutter Z5020 Operator's Manual
Hide thumbs
Also See for TimeCutter Z5020:
- Operator's manual (44 pages) ,
- Operator's manual (48 pages)
Table of Contents
Advertisement
Premaintenance
Procedures
Raising the Seat
Make sure the motion control levers are locked in the
park position. Lift the seat forward.
The following components can be accessed by raising
the seat:
• Serial plate
• Service decal
• Seat adjustment knob
• Fuel filter
• Fuses
• Battery cables
Accessing the Battery
1. Raise the seat.
2. Remove the TORX
®
the left cover to the frame as shown in Figure 27.
Figure 27
1. Left cover
2. Torx head fasteners (T25)
3. Lift the plastic cover away from the machine. Retain
all fasteners.
Replace the cover and secure it to the frame using the
fasteners removed previously.
head fasteners (T25) securing
3. Battery
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings (Figure 28 and Figure 29)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
1. Front caster tire
Located on the seat pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check tire pressure every
25 operating hours.
28
1
G005066
Figure 28
Figure 29
3. Grease every 25 operating
hours.
4. Engine
Advertisement
Table of Contents
