Table of Contents
Advertisement
Required Hardware for Installation
You will need the following tools to perform an installation:
•
Network cables with RJ45 connectors long enough for your particular mounting location
•
802.3at PoE power source (either PoE switch or PoE Injector)
•
Connection to the Internet (if you are setting up your CW9163E as a gateway to the Internet)
•
Appropriately sized metal straps (if mounting to a pole larger than 3.9" in diameter)
•
Screws- should be up to 6 mm in diameter and at least 1 - 1/4 inch length
•
Mounting anchors appropriate for installation surface
Installation Instructions
For most mounting scenarios, the MA-MNT-MR-16 provides a quick, simple, and flexible means of mounting the CW9163E. The installation should be done in
two steps. First, install the mount plate to your selected location. Then, attach the CW9163E to the mount plate.
Warning: Due to the heat dissipation in the back of APs during normal operation, please do not stack powered-on APs on top of each other during
pre-installation to avoid heat damage.
10
Advertisement
Table of Contents
