Cisco Firepower 1010 Getting Started Manual page 102
Hide thumbs
Also See for Firepower 1010:
- Getting started manual (190 pages) ,
- Hardware installation manual (50 pages) ,
- Getting started (42 pages)
Table of Contents
Advertisement
Cable the Device (6.5 and 6.6)
Figure 39: Cabling the Firepower 1010
Note
For version 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
Procedure
Step 1
Connect Management1/1 directly to one of the switch ports, Ethernet1/2 through 1/8.
Step 2
Cable the following to the switch ports, Ethernet1/2 through 1/8:
• Firepower Management Center
• Management computer
• Additional end points
Step 3
Connect the management computer to the console port. You need to use the console port to access the CLI
for initial setup if you do not use SSH to the Management interface.
Step 4
Connect Ethernet 1/1 to your outside router.
Cisco Firepower 1010 Getting Started Guide
100
Firepower Threat Defense Deployment with FMC
Advertisement
Chapters
Table of Contents
