Table of Contents
Advertisement
Checking and Adjusting the
Auger/Impeller Cable
Check and adjust the auger/impeller cable after the
first 2 operating hours, then annually thereafter.
1. Remove the 2
screws from the right
side of the belt cover as
shown.
2. Lift up the right side
of the belt cover.
3. With the auger/impeller lever disengaged, ensure
that the gap between the auger clutch assembly and
the tab (A) is 1/16 inch (1.5 mm).
1/16 inch (1.5 mm)
A
A
4. If the auger/impeller cable is not properly
adjusted, do the following steps:
5. Loosen the jam
nut (A).
6. Loosen or tighten
the turnbuckle (B) that
adjusts the tension on
the cable.
m-6922
B
A
m-6903
3329-808 Rev A
15
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws you previously removed on
the belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
Checking the Auger
Gearbox Oil Level
Check the auger gearbox oil annually, and add oil if
necessary.
1. Move the snowthrower to a level surface.
2. Clean the area around the pipe plug.
3. Remove the pipe plug from the gearbox.
4. Check the level of oil in the gearbox. The oil
should be at the point of overflowing at the filler
opening.
5. If the level of oil is low, add GL-5 or GL-6,
SAE 85–95 EP transmission oil to the gearbox until
the point of overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
652
m-6937
Advertisement
Table of Contents
