Pioneer SE-MJ553BT - Wireless Bluetooth Stereo Headphones Quick Start Guide

Set Contents

Confirm the presence of all parts and components before use.

1. Headphones
2. Micro-USB cable
3. Warranty (Europe / U.S.A. and Canada / Japan)
4. Quick Start Guide (this document)
5. Safety Guide

Names of Parts

1. ( + ) button
2. ( – ) button
3. ( ) button
4. Micro-USB port
5. LED indicator
6. Microphone

Charging the batteries

Connect the appropriate connector on the accessory micro-USB cable to the microUSB port on the headphones, and the USB plug on the other end to a USB port on a computer (see Fig. 3).

• When recharging begins, the LED indicator on the headphones will light red.
• Full recharging requires about 4 hours; when recharging is completed, the LED indicator will turn off.

Note

• Battery recharging time and usable battery time may vary depending on ambient temperature and frequency of use.

Notes on battery charging

• Battery performance is influenced by the surrounding temperature. Charge the supplied rechargeable batteries within a temperature range of 10 to 35 degrees celcius.
• Batteries become slightly warm when charging. This is not a malfunction.
• Recharging may not be possible if computer is in power-saving mode.
• This device cannot be used during charging.

Pairing

1. While the power of the unit is off, hold down the ( ) button until the unit enters pairing mode.
   • The pairing mode is confirmed by the LED indicator's alternately flashing blue and red.
     Release the ( ) button after confirming that the LED indicator is alternately lighting blue and red.
2. Turn on the power to the Bluetooth device you wish to pair with, and begin pairing; search for this unit (wireless headphones) from the paired Bluetooth device.
   • Set theBluetooth device close (within one meter) to the wireless headphones.
   • These wireless headphones will appear in theBluetooth device's display as "SE-MJ553BT".
3. Confirm that pairing has been successfully completed with the Bluetooth device.
   • Look at the display for the Bluetooth-enabled device and select "SE-MJ553BT".
   • When the LED lamp is flashing in blue slowly about once every 3 seconds, pairing is complete. When it is flashing quickly about once every second, pairing is not complete.
   • The PIN code for these wireless headphones has been factory set at "0000". Input this code if requested by the Bluetooth device.

Connect to the Bluetooth device

• Confirm that the power to the wireless headphones is ON before connecting to the Bluetooth device.
• Depending on the device, connection between the wireless headphones and Bluetooth device may be effected automatically after pairing.

Disconnecting from the Bluetooth device

• Hold down the () button until the flashing LED lamp turns off and the power of the device turns off.

Specifications

^*1 Transmission distance is an approximation. Actual usable distance may vary depending on surrounding conditions.
^*2 This product utilizes radio waves in the 2.4 GHz spectrum. Some signal dropouts may be experienced due to interference with radios, microwave ovens, and other devices using the 2.4 GHz spectrum.

Note
Specifications and design are subject to possible modifications without notice due to improvements.