Table of Contents
Advertisement
Quick Links
I N F O
INSTALLATION
INSTRUCTIONS POUR L'INSTALLATION
INSTALLATION
L I B R E T T O
KÜHL- GEFRIERSCHRANK
REFRIGERATEUR - CONGELATEUR
FRIDGE - FREEZER
FRIGORIFERO - CONGELATORE
2222 309-81
-
UND
GEBRAUCHSANWEISUNGEN
AND
INSTRUCTION
ET
L'EMPLOI
MANUAL
I S T R U Z I O N I
ER 8137 I
ER 8137 I
ER 8137 I
ER 8137 I
Advertisement
Table of Contents
Related Manuals for Electrolux ER 8137 I
Summary of Contents for Electrolux ER 8137 I
- Page 1 INSTRUCTION MANUAL L I B R E T T O I S T R U Z I O N I KÜHL- GEFRIERSCHRANK ER 8137 I REFRIGERATEUR - CONGELATEUR ER 8137 I FRIDGE - FREEZER ER 8137 I FRIGORIFERO - CONGELATORE...
- Page 2 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
-
Page 3: Table Of Contents
Environment Protection Installation During normal operation, the condenser and This appliance does not contain gasses compressor at the back of the appliance heat which could damage the ozone layer, in up considerably. For safety reasons, minimum either its refrigerant circuit or insulation ventilation must be as shown in the relevant materials. -
Page 4: Installation
INSTALLATION Cleaning the interior If this appliance featuring magnetic door seals is to replace an older appliance Before using the appliance for the first time, having a spring lock (latch) on the door or wash the interior and all internal accessories lid, be sure to make that spring lock with lukewarm water and some neutral soap unusable before you discard the old... -
Page 5: Instructions For Totally Built-In
I nstructions for totally built-in appliances Door reversibility (Fig. 1) D114 Left opening Right opening Remove (P) from both sides and the door. Remove the pins (P) and (P1) Remove the middle hinge (A) and refit it on the opposite side. Refit the door and (P) on the left I nstructions for totally built-in side. - Page 6 Push appliance into the housing until stop strip Fig. 4 (A) touches the kitchen unit. D023 Fig. 5 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A).
-
Page 7: Electrical Connection
Position the runners (A) at the top and bottom Fig. 9 of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. PR33 Fig. -
Page 8: Use
Operation the thermostat knob to the coldest setting; but remember that, in this condition, the refrigerating compartment temperature might Insert the plug into the wall socket. drop below 0°C. If this occurs reset thermostat Open the refrigerator door and turn the knob to a warmer setting. -
Page 9: Thawing
If large quantities of food are to be stored, Ice-cube production remove all drawers and baskets from appliance This appliance is equipped with one or more and place food on cooling shelves. Pay careful trays for the production of ice-cubes. Fill these attention not to exceed load limit stated on trays with water, then put them in the freezer... -
Page 10: Positioning The Door Shelves
Positioning the door shelves Fig. 14 To permit storage of food packages of various sizes, the door shelves can be adjusted in height.To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required. -
Page 11: Maintenance
MAINTENANCE Interior light Unplug the appliance before carrying out any maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Warning This appliance contains hydrocarbons in its unscrew the light cover securing screws; cooling unit maintenance and recharging must therefore only be carried out by authorized unhook the moving part by pressing it as technicians. - Page 12 Servicestellen Points de service Servizio post-vendita Zürich/Mägenwil 1204 Genève 6915 Noranco 5506 Mägenwil Rue des Rois 15 Strada Noranco-Figino Industriestrasse 10 8762 Schwanden 1028 Préverenges Sernftalstrasse Route d’Yverdon/Le Trési 9202 Gossau 3966 Réchy Route de Grône Poststrasse 10 4133 Pratteln Rheinpark-Center Netzibodenstrasse 23 b 8400 Winterthur...