hit counter script
Toro Super Recycler 21386 Operator's Manual
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. Super Recycler 21386
  6. Operator's manual
Toro Super Recycler 21386 Operator's Manual

Toro Super Recycler 21386 Operator's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Super Recycler
Model No. 21386—Serial No. 400000000 and Up

Introduction

This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners. It is designed
primarily for cutting grass on well-maintained lawns on
residential properties. Using this product for purposes
other than its intended use could prove dangerous to
you and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for more information, including
safety tips, training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the product model and serial
numbers in the space provided.
Important:
With your mobile device, you can
scan the QR code on the serial number decal (if
equipped) to access warranty, parts, and other
product information
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Figure 1
Register at www.Toro.com.
®
Lawn Mower
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
It is a violation of California Public Resource Code
Section 4442 or 4443 to use or operate the engine on
any forest-covered, brush-covered, or grass-covered
land unless the engine is equipped with a spark
arrester, as defined in Section 4442, maintained in
effective working order or the engine is constructed,
equipped, and maintained for the prevention of fire.
The enclosed engine owner's manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California Emission
Control Regulation of emission systems, maintenance,
and warranty. Replacements may be ordered through
the engine manufacturer.
Gross or Net Torque: The gross or net torque
of this engine was laboratory rated by the engine
manufacturer in accordance with the Society of
Automotive Engineers (SAE) J1940 or J2723. As
configured to meet safety, emission, and operating
requirements, the actual engine torque on this class
of mower will be significantly lower. Please refer to
the engine manufacturer's information included with
the machine.
g282705
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Use of this product may cause exposure
to chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Form No. 3435-722 Rev B
Operator's Manual
Figure 2
Safety-alert symbol
WARNING
CALIFORNIA
Proposition 65 Warning
Original Instructions (EN)
All Rights Reserved *3435-722* B
Printed in Mexico
g000502

Advertisement

Table of Contents
loading

Related Manuals for Toro Super Recycler 21386

Summary of Contents for Toro Super Recycler 21386

  • Page 1: Introduction

    Whenever you need service, genuine Toro parts, or equipped, and maintained for the prevention of fire. additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model The enclosed engine owner's manual is supplied and serial numbers of your product ready.

  • Page 2: Table Of Contents

    Contents Safety Introduction ............... 1 This machine has been designed in accordance with Safety ............... 2 ANSI B71.1-2017. General Safety ........... 2 Safety and Instructional Decals ......3 General Safety Setup ................ 4 1 Unfolding the Handle ........4 This product is capable of amputating hands and 2 Installing the Recoil-Starter Rope in the feet and of throwing objects.

  • Page 3: Safety And Instructional Decals

    Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decaloemmarkt Manufacturer's Mark 1. This mark indicates that the blade is identified as a part from the original machine manufacturer.

  • Page 4: Setup

    Setup Important: Remove and discard the protective plastic sheet that covers the engine and any other plastic or wrapping on the machine. Unfolding the Handle No Parts Required Procedure g301241 Figure 3 Installing the Recoil-Starter Rope in the Rope Guide No Parts Required Procedure Important:...

  • Page 5: Adding Oil To The Engine

    g230719 Figure 4 Adding Oil to the Engine No Parts Required Procedure Important: If the oil level in the engine is too low or too high and you run the engine, you may damage the engine. g222533 Figure 5...

  • Page 6: Assembling The Grass Bag

    Assembling the Grass Bag No Parts Required Procedure g241560 Figure 6...

  • Page 7: Product Overview

    Product Overview Operation Note: Determine the left and right sides of the machine from the normal operating position. Before Operation Before Operation Safety General Safety • Always shut off the machine, wait for all moving parts to stop, and allow the machine to cool before adjusting, servicing, cleaning, or storing it.

  • Page 8: Filling The Fuel Tank

    – Avoid prolonged breathing of vapors. – Keep your hands and face away from the nozzle and the fuel-tank opening. – Keep fuel away from your eyes and skin. Filling the Fuel Tank • For best results, use only clean, fresh, unleaded gasoline with an octane rating of 87 or higher ((R+M)/2 rating method).

  • Page 9: Checking The Engine-Oil Level

    Checking the Engine-Oil Level Service Interval: Before each use or daily Important: If the oil level in the crankcase is too low or too high and you run the engine, you may damage the engine. g222533 Figure 10 Adjusting the Handle Height You may raise or lower the handle to a position comfortable for you.

  • Page 10: Adjusting The Cutting Height

    Adjusting the Cutting Height CAUTION If the engine has been running, the muffler will be hot and can severely burn you. Keep away from the hot muffler. Adjust the cutting height as desired. Set all wheels to the same cutting height (Figure 12).

  • Page 11: Starting The Engine

    Exhaust gases contain carbon monoxide, which is lethal if inhaled. • Check the grass catcher components and the discharge chute frequently for any wear or deterioration and replace them with genuine Toro g233422 parts when necessary. Figure 13 Slope Safety •...

  • Page 12: Using The Self-Propel Drive

    Using the Self-Propel Drive Shutting Off the Engine To operate the self-propel drive, simply walk with your Service Interval: Before each use or daily hands on the upper handle and your elbows at your To shut off the engine, release the blade-control bar. sides, and the machine will automatically keep pace with you (Figure...

  • Page 13: Bagging The Clippings

    Bagging the Clippings Use the grass bag when you want to collect grass and leaf clippings from the lawn. If the side-discharge chute is on the machine, remove it and lock the side-discharge deflector; refer to Removing the Side-Discharge Chute (page 15).

  • Page 14: Discharging The Clippings

    Removing the Grass Bag Raise and hold up the rear deflector and lift the grass bag up by the handle off the notches of the handle brackets (A of Figure 17). Install the rear plug (B of Figure 17). Important: Ensure that the rear plug is locked in place.
  • Page 15 g231918 Figure 18 Note: To unlock the plug, rotate the lever on the plug to the right. Installing the Side-Discharge Chute Unlock the side-discharge deflector (A of Figure 19). Lift open the side-discharge deflector (B of Figure 19). Install the side-discharge chute and close the deflector onto the chute (B, C, and D of Figure 19).
  • Page 16 g002593 Figure 20...

  • Page 17: Operating Tips

    • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time.

  • Page 18: After Operation

    Cleaning under the Machine After Operation Service Interval: Before each use or daily After Operation Safety WARNING The machine may dislodge material from General Safety under the machine. • Always shut off the machine, wait for all moving • Wear eye protection. parts to stop, and allow the machine to cool before adjusting, servicing, cleaning, or storing it.

  • Page 19: Folding The Handle

    Folding the Handle WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. Hold the handle while disengaging the handle locks to avoid pinching your hands.

  • Page 20: Maintenance

    • To ensure optimum performance of the machine, use only genuine Toro replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, and such use could void the product warranty.

  • Page 21: Preparing For Maintenance

    Preparing for Maintenance Servicing the Air Filter Shut off the engine and wait for all moving parts Service Interval: Every 25 hours to stop. Yearly Disconnect the spark-plug wire from the spark Unclip the top of the air-filter cover (Figure 24).

  • Page 22: Changing The Engine Oil

    Changing the Engine Oil Service Interval: Yearly Changing the engine oil is not required, but if you want to change the oil, use the following procedure. Note: Run the engine a few minutes before changing the oil to warm it. Warm oil flows better and carries more contaminants.

  • Page 23: Lubricating The Wheel Gears

    Lubricating the Wheel Replacing the Blade Gears Service Interval: Yearly Important: You will need a torque wrench to Service Interval: Every 25 hours install the blade properly. If you do not have a Wipe the grease fittings just inside the rear torque wrench or are uncomfortable performing wheels with a clean rag (Figure...

  • Page 24: Adjusting The Self-Propel Drive

    g269307 Figure 30 1. Handle (left side) 4. Turn the nut clockwise to tighten the adjustment. 2. Adjustment nut 5. Turn the nut counterclockwise to loosen the adjustment. 3. Self-propel-drive cable Adjust the tension on the cable (Figure 30) by g231390 Figure 29 pulling it back or pushing it forward and holding...

  • Page 25: Storage

    On the last refueling of the year, add fuel the starter rope slowly several times to distribute stabilizer (such as Toro Premium Fuel oil throughout the cylinder to prevent cylinder Treatment) to the fuel as directed on the label.

  • Page 26: Removing The Machine From Storage

    Note: If the level of fuel in the fuel tank is too high, drain the fuel from the fuel tank into an approved fuel container until it is at or below the level recommended by the engine manufacturer (A of Figure 32).
  • Page 27 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.

Table of Contents