Cleaning The Print Head - Brother MFC-J6925DW Basic User's Manual
Hide thumbs
Also See for MFC-J6925DW:
- Quick setup manual (47 pages) ,
- Service manual (365 pages) ,
- Advanced user's manual (95 pages)
Table of Contents
Advertisement
NOTE
In addition to cleaning the glass strip with
a non-flammable glass cleaner, run your
finger tip over the glass strip to see if you
can feel anything on it. If you feel dirt or
debris, clean the glass strip again
concentrating on that area. You may need
to repeat the cleaning process three or
four times. To test, make a copy after each
cleaning attempt.
i
When there is a
spot of dirt or
correction fluid
on the glass strip,
the printed
sample shows a
vertical line.
102
After the glass
strip is cleaned,
the vertical line is
gone.
Cleaning the print head
To maintain good print quality, the machine
will automatically clean the print head when
needed. You can start the cleaning process
manually if there is a print quality problem.
Clean the print head if you get a horizontal
line in the text or graphics, or blank text on
your printed pages. You can clean Black only,
three colours at a time
(Yellow/Cyan/Magenta), or all four colours at
once.
Cleaning the print head consumes ink.
Cleaning too often uses ink unnecessarily.
IMPORTANT
DO NOT touch the print head. Touching
the print head may cause permanent
damage and may void the print head's
warranty.
a
Press
.
NOTE
You can also press
b
Press Cleaning.
c
Press Black, Colour or All.
The machine cleans the print head.
When cleaning is finished, the machine
will go back to the Ready mode.
A
and then Ink.
Advertisement
Chapters
Table of Contents
