Table of Contents
Advertisement
3. Slide the bag support rod through the second from
the top mounting holes in the handle and secure
each end with a cap locknut (Figure 3).
4. Use a cable tie to secure the control cables to the left
handle below the bag support rod.
2
Installing the Fuel Tank
Parts needed for this procedure:
2
Self-tapping screw
1
Fuel tank
Procedure
1. Slide the plastic clips on the front of the fuel tank
onto the fuel tank mount (Figure 4).
1. Plastic clip (2)
2. Secure the bottom of the fuel tank to the fuel tank
bracket by installing the self-tapping screws from the
bottom. Torque the screws to 40 to 50 in-lb (4.5
to 5.6 N-m). Do not overtighten the screws.
Figure 4
3
Installing the Discharge Tunnel
Plug
Parts needed for this procedure:
1
Discharge tunnel plug
Procedure
1. Open the discharge door by pulling forward on the
handle and moving it rearward (Figure 5). Hold the
discharge door handle to prevent the spring-loaded
door from closing while you insert the plug.
1. Discharge door handle
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Figure 5).
Note: Ensure that the arrow on the plug decal
points upward.
3. Push the plug all the way in until the spring clip on
the bottom of the plug clicks into place, locking the
plug securely into the discharge tunnel (Figure 6).
8
Figure 5
2. Plug, rotated clockwise
Advertisement
Table of Contents
