Table of Contents
Advertisement
Problem
There is no power to the display.
The monitor is frozen.
The sprayer does not spray.
The No GPS alarm is on.
The sprayer sprays outside boundaries.
You cannot create boundaries.
The machine is not shown on the screen.
The lights are not blinking on the GPS
reciever located on the ROPS.
The pressure is not high enough.
The controller lights not on at the rear
controllers.
The speed is not showing when moving.
There is condensation inside the display.
All manuals and user guides at all-guides.com
Possible Cause
1. The connectors are not installed
correctly.
2. The fuse for the display is blown.
3. The battery connections are loose.
1. There is a malfunction with the
software.
1. The foot switch is off.
2. The switches on the console between
the seats are off.
3. No job and boundary are created.
4. The incorrect nozzle is selected in
sprayer-control setup menu.
1. The display is not connected to GPS
receiver correctly
2. The machine is under trees or other
obstructions.
1. The auto section control (ASC) is set
to unlimited.
1. The display is not in standard mode.
2. There is no field created.
1. The display screen has been moved.
1. There is no power to the GPS reciever.
1. The nozzle size used is incorrect.
2. The nozzle size selected in the display
does not match the nozzles on the
booms.
3. The agitation is set too low.
1. There is no power to the rear controller.
1. The compass is not calibrated.
2. The reciever is lacking satalite
reception.
3. The vehicle ground speed is less than
1.1 km/h (0.7 mph).
1. The display warms up too quickly in
direct sunlight with the display at 100
percent brightness.
17
Corrective Action
1. Ensure the connectors are installed
correctly at the back of the display,
2. Replace the fuse.
3. Secure the battery connections.
1. Hold in the green button on the back
of the display until the front LED lights
flash.
1. Ensure the foot switch is on.
2. Ensure the switches on the console
are on.
3. Create a job and boundary.
4. Select the correct nozzle in
sprayer-control setup menu that
matches the nozzles being used.
1. Ensure the connections are installed
correctly.
2. Allow the machine to make connection
after driving under obstructions.
1. Set the auto section control (ASC) to
field boundary.
1. Switch the user profile to standard
mode.
2. Create a field.
1. Select the center-map icon on the main
screen.
1. Ensure the connectors are installed
correctly.
1. Refer to the nozzle selection chart for
the proper nozzle sizing.
2. Ensure the nozzle size selected in the
display matches the boom nozzles.
3. Adjust the agitation until the desired
pressure is realized.
1. Ensure the connectors are installed
correctly.
1. Calibrate the compass.
2. Drive away from reception obstructions
and allow time for the reciever to
connect to the satellites.
3. Increase the speed above 1.1 km/h
(0.7 mph).
1. Change the screen brightness to 85
percent and allow the display to warm
up.
Advertisement
Table of Contents
