Page 1
Operator’s Manual TS 142 Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. Please read the operator's manual carefully and make sure 114 14 52-28 Rev.
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Be alert and turn machine off if a child enters the area. WARNING: In order to prevent ac ci den tal •...
Page 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. SLOPE OPERATION • Never remove gas cap or add fuel with the engine running. • Allow engine to cool before refueling. WARNING! When loading or unloading • Never fuel the machine indoors. this machine, do not exceed the maximum •...
SUPPORT / HELP If you require assistance or have questions concerning the application, operation, maintenance or parts for your product: • Visit our website: www.husqvarna.com • Call Us Toll Free: 1-800-487-5951 TABLE OF CONTENTS SAFETY RULES ............2-3 MAINTENANCE SCHEDULE ........
Page 5
UNASSEMBLED PARTS Steering Wheel (1) Large (1) Lock Flat Washer Washer Steering Wheel Insert Steering Wheel (1) Hex Bolt (4) Screws Steering Wheel Steering Adapter Steering Mount Steering Boot Extension Shaft Battery Keys Oil Drain Extension Slope Sheet (2) Hex Bolts (2) Nut Keps Key(s) Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
ASSEMBLY CONNECT BATTERY (See Fig. 1) • Snap steering wheel insert into center of steer ing wheel. • Remove protective materials from trac tor hood and WARNING: Do not short battery ter mi nals grill. by allowing a wrench or any other object to contact both terminals at the same IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO...
Page 7
ASSEMBLY ✓ CHECK TIRE PRESSURE CHECKLIST The tires on your tractor were overinfl ated at the factory for shipping purposes. Correct tire pressure is important BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE for best cutting performance. WISH TO ENSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS •...
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. REVERSE NEUTRAL HIGH CHOKE FAST SLOW IGNITION SWITCH ENGINE ENGINE ENGINE DIFFERENTIAL CLUTCH/ PARKING MOWER MOWER START LOCK BRAKE PEDAL BRAKE HEIGHT LIFT...
Page 9
OPERATION KNOW YOUR TRACTOR READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. Fig.
Page 10
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses.
Page 11
OPERATION TO ADJUST MOWER CUTTING HEIGHT TO OPERATE MOWER (See Fig. 8) Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with The position of the attachment lift lever (A) determines the the engine running and the attachment clutch engaged will cutting height.
Page 12
OPERATION TOWING CARTS & OTHER AT TACH MENTS WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the Tow only the attachments that are recommended by and ROS "ON", to allow reverse operation with the attachment comply with specifi...
Page 13
OPERATION AUTOMATIC TRANSMISSION WARM UP CAUTION: Alcohol blended fuels (called gasohol • Before driving the unit in cold weather, the trans mis sion or using ethanol or methanol) can attract moisture should be warmed up as follows: which leads to sep a ra tion and for ma tion of acids •...
Page 14
OPERATION MOWING TIPS • DO NOT use tire chains when the mower hous ing is attached to tractor. • Mower should be properly leveled for best mowing performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. •...
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE SCHEDULE EACH SEASON STORAGE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure Check Operator Presence and ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Clean Debris off Steering Plate Check Transaxle Cooling...
MAINTENANCE TRACTOR BLADE CARE For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. BRAKE OPERATION CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor.
Page 17
MAINTENANCE V-BELTS CAUTION: If engine has been operated Check V-belts for deterioration and wear after 100 hours for an extended period of time immedi- of operation and replace if necessary. The belts are not ately prior to draining oil, oil will be hot. ad just able.
Page 18
MAINTENANCE ENGINE COOLING SYSTEM CLEANING To ensure proper cooling, make sure the grass screen, • Clean engine, battery, seat, fi nish, etc. of all foreign cooling fi ns, and other external surfaces of the engine are matter. kept clean at all times. •...
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. •...
Page 20
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring.
Page 21
SERVICE AND ADJUSTMENTS TO LEVEL MOWER FRONT-TO-BACK ADJUSTMENT (See Figs. 28 & 29) IMPORTANT: Deck must be level side-to-side. Ensure tires are properly infl ated to the PSI shown on tires. If tires are over or under infl ated, it may affect the appear- To obtain the best cutting re sults, the mower blades should ance of your lawn and lead you to think the mower is not be adjusted so the front tip is 1/8"...
Page 22
SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT TO REPLACE MOTION DRIVE BELT (See Fig. 30) (See Fig. 31) Park the tractor on level surface. En gage parking brake. The mower blade drive belt may be replaced without tools. Park the tractor on level surface.
Page 23
SERVICE AND ADJUSTMENTS TO REMOVE WHEEL (See Fig. 32) TO START ENGINE WITH A WEAK BATTERY (See Fig. 33) • Block up axle securely. • Remove axle cover, retaining ring and washers to allow WARNING: Lead-acid batteries gen er ate wheel removal (rear wheel contains a square key - Do ex plo sive gases.
Page 24
SERVICE AND ADJUSTMENTS REPLACING BATTERY (See Fig. 34) TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35) WARNING: Do not short battery • Raise hood. ter mi nals by allowing a wrench or any • Unsnap headlight wire connector. other object to contact both terminals •...
STORAGE ENGINE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS WARNING: Never store the trac tor with FROM FORMING IN ES SEN TIAL FUEL SYSTEM PARTS SUCH gas o line in the tank inside a building AS CARBURETOR, FUEL FIL TER, FUEL HOSE, OR TANK...
TROUBLESHOOTING PROBLEM CAUSE CORRECTION 1. Out of fuel. 1. Fill fuel tank. Will not start 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine fl ooded. 3. Wait several minutes before attempting to start. 4.
Page 27
TROUBLESHOOTING PROBLEM CAUSE CORRECTION Engine continues to 1. Faulty operator-safety presence control 1. Check wiring, switches and connections. If not run when operator system. corrected, contact an authorized service center/ department. leaves seat with attachment clutch CAUTION: DO NOT operate machine until engaged problem is corrected.