Activate The Battery - Toro Z255 Operator's Manual
With 52 sfs side discharge mower
Hide thumbs
Also See for Z255:
- Operator's manual (68 pages) ,
- Operator's manual (52 pages) ,
- Operator's manual (64 pages)
Table of Contents
Advertisement
Assembly
Activate the Battery
Bulk electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet.
1.
Tilt seat up and remove battery.
2.
First disconnect the negative battery cable and
ground wire from the negative (–) battery
terminal.
3.
Slide the red terminal boot off the positive (red)
battery terminal. Then remove positive (red)
battery cable.
4.
Remove battery hold down clamp.
IMPORTANT: Be careful not to damage the
long vent tube when removing the battery
box.
POTENTIAL HAZARD
Battery electrolyte contains sulfuric acid
which is a deadly poison and it causes
severe burns.
WHAT CAN HAPPEN
If you carelessly drink electrolyte you could
die or if it gets onto your skin you will be
burned.
HOW TO AVOID THE HAZARD
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
Fill the battery where clean water is always
available for flushing the skin.
Follow all instructions and comply with all
safety messages on the electrolyte container.
5.
Remove battery from machine.
6.
Place battery on a level surface.
20
7.
Remove filler caps from the battery. Slowly pour
electrolyte into each cell until the electrolyte
level is up to the lower part of the tube (Fig. 5).
Figure 5
1. Filler caps
2. Electrolyte
8.
Leave the covers off and connect a 3 to 4 amp
battery charger to the battery posts (Fig. 6).
Charge the battery at a rate of 4 amperes or less
for 3–5 hours (12 volts).
4
Figure 6
1. Positive post
2. Negative post
1
3
m–1262
3. Lower part of the tube
2
3
1
m–1254
3. Charger red (+) wire
4. Charger black (–) wire
2
Advertisement
Table of Contents
