Table of Contents
Advertisement
Overview
Figure 5: Secure Firewall 3100 Front Panel
1
SSD-1
System LEDs
3
5
Type A USB 3.1 port
7
Reset button LED
9
Pullout asset card with chassis serial number,
getting started guide QR code, and LTP QR code
11
Fixed fiber ports (NM-1)
Fiber ports named 1/9 through 1/16 left to right
Management Port
The Secure Firewall 3100 chassis management port is a 1/10-Gb fiber SFP port.
RJ-45 Console Port
The Secure Firewall 3100 chassis has a standard RJ-45 console port. You can use the CLI to configure
your 3100 through the RJ-45 serial console port by using a terminal server or a terminal emulation
program on a computer.
The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The console port does
not have any hardware flow control, and does not support a remote dial-in modem. The baud rate is 9600.
You can use the standard cable found in your accessory kit to convert the RJ-45 to DB-9 if necessary.
Type A USB 3.1 Port
You can use the external Type A USB port to attach a data-storage device. The external USB drive
identifier is
. The Type A USB port supports the following:
usb:
• Hot swapping
2
SSD-2
RJ-45 console port
4
6
Gigabit Ethernet management port:
• Secure Firewall Threat
Defense—Management 0 (also referred to
as Management 1/1 and Diagnostic 1/1)
• ASA—Management 1/1
8
Recessed factory reset button
10
Fixed copper ports (NM-1)
Copper ports named 1/1 through 1/8 left to right
12
Network module (NM-2)
Cisco Secure Firewall 3100 Series Hardware Installation Guide
Front Panel
9
Hide quick links:
Advertisement
Table of Contents
