Page 1
Operating and Installation Instructions Gas Cooktop Model: CGA60WOK-F CGA76WOK-F CGA90WOK-F en - US To prevent accidents and machine damage, read the Operating Manual before 1 di 30 installation or use. 10/01/14...
Page 2
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
IMPORTANT SAFETY INSTRUCTIONS Installation and connection Before servicing, turn off the gas valve and disconnect the power supply When using your gas appliance by either removing the fuse, unplugging follow basic safety precautions the unit or manually “tripping” the including the following: circuit breaker.
IMPORTANT SAFETY INSTRUCTIONS Correct usage Do not use pans that extend past the burner grate. Using larger pans Do not operate the cooktop until it is may cause the flames to spread out properly installed in the countertop. and damage the surrounding This appliance is intended for countertop or other countertop residential cooking only.
Page 5
IMPORTANT SAFETY INSTRUCTIONS Personal safety Do not leave the cooktop unattended while in use. Boil-overs The burners become very hot when cause smoking, and greasy spill-overs in use. Make sure that no one comes in may ignite. contact with them. Do not use water on grease fires.
Page 6
IMPORTANT SAFETY INSTRUCTIONS Damage to the appliance Further safety notes In the event of damage or a defect, When using a portable appliance turn off the appliance immediately. Turn near the cooktop, make sure that its off the gas shut off valve and power cord does not come in contact disconnect completely from the with the cooktop.
Before using the cooktop Cleaning the cooktop Metal components have a protective coating which may give off a slight odor Before using for the first time clean the the first time your new appliance is appliance as follows: heated. ^ Wash the gas burner assembly with a The harmless odor will dissipate after a mild solution of warm water and short time and does not indicate a...
Using the cooktop Turning off Ignition-System ^ Turn the control knob clockwise to The gas cooktops are equipped with a “ß”. Fast-Ignition-System which incorporates the following features: This stops the flow of gas and turns off the cooktop. – The control knob can be released once it is turned to the largest flame The knob must only be turned left to symbol.
Page 9
Using the cooktop Pan size Suitable pans – Set the cooktop to a high flame when Unlike pans used on an electric using a large diameter pan and low cooktop, the bases do not need to be flame when using small diameter even for good results.
Page 10
Using the cooktop Mini Trivet The mini-trivet included with this cooktop is to be used for cooking vessels of diameter 120mm or smaller Incorrect fitment Correct fitment Examples of positioning of mini-trivet MODEL:CGA60WOK-F MODEL:CGA76WOK-F MODEL:CGA90WOK-F 10/01/14 10 di 30...
Cleaning and care Cooktop Never use a steam cleaner to clean Let the appliance cool to a safe this cooktop. Pressurized steam temperature before removing the could cause permanent damage to grates. the surface and to components. ^ Clean the grates, cooktop and knobs with a sponge and a mild solution of Do not use any sharp or pointed objects which could damage the...
Page 12
Cleaning and care Burners The burners can be dismantled and cleaned when cool. ^ Remove the burner parts and wash them in a solution of hot water and liquid dish soap. Dry them thoroughly. Make sure that the flame holes are clean and completely dry. ^ Wipe the burner base clean with a damp cloth and then dry.
Frequently asked questions Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The burners do not ignite after several attempts. Possible fault – The burners are assembled –...
Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the cooktop. This information is visible on the silver data plate supplied with the cooktop.
Installation Instructions To prevent accidents and machine damage read these instructions before 15 di 30 installation or use. 10/01/14...
Page 16
IMPORTANT SAFETY INSTRUCTIONS Installation The minimum distances given in these Installation instructions are to combustible surfaces, and must be observed to ensure safe operation. Failure to do so increases the risk of fire. The cabinetry and venting hood should be installed first to prevent recommended damage to the cooktop.
IMPORTANT SAFETY INSTRUCTIONS Safety distances above the The cooktop must not be installed over a dishwasher, washer, dryer, appliance refrigerator or freezer. Heat radiated by the cooktop may damage the appliances. Deep fat fryers must not be installed next to gas cooktops. Gas flames can ignite splattering oil.
Installation ^ Prepare the work top cut-out as shown in the diagram. Rember to maintain the minimum safety distances to combustible surfaces: " (70 mm) between the cut-out and the back wall and - 12" (305 mm) between the cut-out and a side wall or tall unit to the right or left of the cut-out.
Page 22
Installation Setting the cooktop into place Securing the cooktop ^ Secure the cooktop with the included fixing bracket. ^ After removing the protective backing, stick the supplied seal,under the edge of the cooktop. ^ Screw the gas regulator onto the nipple underneath the cooktop.
Page 23
Installation The sealing strip under the edge of the top part of the cooktop provides a sufficient seal for the worktop. Do not let sealant get in between the cooktop frame and the worktop. This could cause difficulties if the cooktop ever needs to be taken out for servicing and possibly result in damage to the cooktop frame or the...
Electrical connection This appliance must be grounded This appliance is equipped with a according to local or national codes. three-prong grounding plug to prevent shock hazards. It should be All electrical work should be plugged directly into a properly performed by a qualified electrician grounded outlet.
Gas connection Installation and service must be The gas connection must be made performed by a qualified installer, in accordance with local codes or, in service agency or gas supplier. the absence of local codes, with In Massachusetts a licensed the National Fuel Gas Code, plumber / gas fitter is required.
Gas connection Gas pressure regulator For convenience, an AGA or CGA approved flexible stainless steel gas A pressure regulator that is convertible hose (accordion type) may be used from natural to LP gas (Propane) or vice between the gas connection and the versa is included with the appliance.
Page 28
Gas connection Nominal Rating Table 28 di 30 10/01/14...
Converting to another type of gas GAS TRANSFORMATIONS AND ADJUSTMENTS Replacing the nozzles If the equipment is adjusted for a type of gas that is different from the original, it is necessary to replace the burner nozzles as well. The nozzles used to replace the original must be in accordance with the table of the technical characteristics enclosed.
Help protect our environment Disposal of packing materials Disposal of an old appliance The cardboard box and packing Old appliances contain materials that materials are biodegradable and can be recycled. Please contact your recyclable. Please recycle. local recycling center about the possibility of recycling these materials.