Table of Contents
Advertisement
The machine should move rearward. If the
machine does not move or moves forward,
complete the following:
A.
Release the traction lever and shut off the
engine.
B.
Disconnect the trunnion from the
speed-selector lever.
C.
Turn the trunnion downward (clockwise) on
the speed-control rod.
D.
Connect the trunnion to the speed-selector
lever.
4.
Release the traction lever.
5.
Move the speed selector to Position 1; refer to
Operating the Speed Selector (page
6.
Squeeze the left (traction) lever to the handgrip
(Figure
10).
The machine should move forward. If the
machine does not move or moves rearward,
complete the following:
A.
Release the traction lever and shut off the
engine.
B.
Disconnect the trunnion from the
speed-selector lever.
C.
Turn the trunnion upward (counterclockwise)
on the speed-control rod.
D.
Connect the trunnion to the speed-selector
lever.
7.
If you made any adjustments, repeat this
procedure until no adjustments are required.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 20)
to an Authorized Service Dealer for service.
15).
Checking and Adjusting
or take the machine
Product Overview
1. Handgrip (2)
2. Auger/impeller lever
3. Speed-selector lever
4. Handwarmer switch
5. Quick Stick®
discharge-chute control
6. Traction lever
7. Fuel-tank cap
8. Oil-fill tube/dipstick
9. Chute deflector
1. Primer
2. Key
3. Choke
4. Fuel-shutoff valve
9
Figure 11
10. Discharge chute
11. Scraper
12. Auger
13. Skid (2)
14. Electric-start button
15. Electric-start plug-in
16. Recoil-start handle
17. Snow-cleanout tool
18. Headlight
Figure 12
5. Throttle
6. Recoil-start handle
7. Oil-drain plug
g323591
g323302
- Quick Links:
- Starting the Engine
Hide quick links:
Advertisement
Table of Contents
