Table of Contents
Advertisement
Figure 5-2
Removal from a 35 mm DIN rail
5.4
Installation on a standard rail
Installation on a SIMATIC S7-300 standard rail
To install the device on an S7-300 standard rail, follow the steps below:
1. Place the first housing guide of the device on the top edge of the S7-300 standard rail.
2. Screw the device to the underside of the standard rail (tightening torque 2 Nm).
3. Fit the connectors for the power supply. See also section "Power supply (Page 36)".
SCALANCE X-100
Operating Instructions, 02/2019, A2B00060666-10
5.4 Installation on a standard rail
Assembly
33
Advertisement
Table of Contents
