Cisco Firepower 4100 Manual page 18
Hide thumbs
Also See for Firepower 4100:
- Command reference manual (421 pages) ,
- Hardware installation manual (82 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
40-Gb Network Module with Hardware Bypass
40-Gb Network Module with Hardware Bypass
The following figure shows the front panel of the 40-Gb hardware bypass network module
(FPR4K-NM-2X40G-F). The FPR4K-NM-2X40G-F is a single-wide module that does not support hot
swapping. The two ports are numbered left to right. Pair the two ports to create a hardware bypass paired set.
Note
Figure 12: FPR4K-NM-2X40G-F
1
3
5
Overview
18
Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware
if necessary, see the
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
4100/9300 FXOS Compatibility
Captive screw/handle
Port 2 Ethernet X/2
Ports 1 and 2 are paired together to form a
hardware bypass pair.
BP (bypass LED):
• Green—In standby mode.
• Amber, flashing—Port is in hardware bypass
mode, failure event.
for the software compatibility matrix.
2
Port 1 Ethernet X/1
Ports 1 and 2 are paired together to form a
hardware bypass pair.
4
Port 1 network activity LEDs:
• Amber—No connection, or port is not in use,
or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
6
Port 2 network activity LEDs:
• Amber—No connection, or port is not in use,
or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
Overview
Guide. See
Cisco Firepower
Advertisement
Table of Contents
