Table of Contents
Advertisement
Available languages
Available languages
Operation
Product Overview
1. Rotor blades
2. Belt cover (not shown)
3. Chute deflector
4. Chute-deflector trigger
5. Discharge-chute handle
6. Cord lock
Important:
This appliance is intended for outdoor,
residential use only. Do not use it indoors or for commercial
or industrial purposes.
Connecting to a Power
Source
To reduce the risk of electric shock, this appliance has a
polarized plug (i.e., one blade is wider than the other). Use only
a polarized plug, UL-listed (CSA certified in Canada) extension
cord recommended for outdoor use. A polarized plug will fit in a
polarized cord only one way. If the plug does not fit fully in the
cord, reverse the cord. If it still does not fit, purchase a polarized
extension cord. If you have a polarized extension cord and the
extension cord plug does not fit fully into the wall receptacle,
reverse the plug. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not change the appliance or
extension cord plug in any way.
Figure 3
7. Interlock button (key)
8. Power-control bar
9. Upper handle
10. Cord
11. Handle knobs
12. Discharge chute
DANGER
Contact with water while operating the machine could
cause electric shock, causing injury or death.
•
Do not handle the plug or the machine with wet
hands or while standing in water.
•
Use only an extension cord recommended for
outdoor cold-weather use.
Extension Cord Length
7.6 m (25 ft)
15.2 (50 ft)
30.5 (100 ft)
45.7 (150 ft)
Note:
Do not use an extension cord over 46 meters (150 feet).
Important:
Check the extension cord frequently during
use for holes or cracks in the insulation. Do not use a
damaged cord. Do not run the cord through standing water.
Note:
To prevent the extension cord from disconnecting during
operation, use the cord lock on the upper handle before you
connect it to the machine
g222780
1. Cord lock
WARNING
The electrical cord can get damaged, causing a shock
or fire.
Thoroughly inspect the electrical cord before using the
snowthrower. If the cord is damaged, do not operate
the snowthrower. Repair or replace the damaged cord
immediately. Contact an Authorized Service Dealer for
assistance.
5
Minimum Wire Gauge
(A.W.G.)
16
16
14
10
(Figure
4).
Figure 4
2. Extension cord
g220754
Advertisement
Table of Contents
