Table of Contents
Advertisement
Software Update
Your recorder is able to receive updates to some of its
features and functions. These updates will occur
automatically, usually at times when the recorder
would likely be turned off.
If your recorder is on when an update is sent, you
may experience a disruption in reception for about 10
minutes. Your reception should return to normal after
the update is complete.
Your recorder must be plugged into AC power to
receive any updates. Do not unplug your recorder
while an update is in progress.
Please consult the System Info screen to check for an
upgrade planned by service provider or distributor.
[Standby mode] Press OK ( ) to update the software
when this unit is turned off. Check mark appears.
[Operation Mode] Press OK ( ) to update the
software when this unit is turned on. Check mark
appears.
[Time] Set time to update the software.
[Freq.] Selects frequency to update the software.
(Weekly or Dalily)
[Start] Press OK ( ) to update right now.
Note:
The software update is capable only when you are
watching a broadcasting if the recorder is turned on.
So the update is not available during recording,
playback or viewing the program guide, etc.
System Information
Shows system information about the recorder.
(software version, Conditional Access Serial Number,
DTV signal strength)
27
Advertisement
Table of Contents
