Download Print this page

HP DreamWorks Shrek 3-D puss in boots Assembly Instructions

Download this manual

3-D puss in boots

ASSEMBLY INSTRUCTIONS

Time to complete: Approximately 45 minutes

GETTING STARTED

Materials

• Metal-edged ruler

• Butter knife

• Scissors or craft knife

• Cutting mat (optional)

• Multipurpose glue

Hey kids,

make sure to ask

an adult for help!

ASSEMBLE YOUR PUSS IN BOOTS

Hat feather, feet, hat brim, arms, and tail:

Fold pieces in half and glue together.

Cut out shapes along solid gray lines.

Body: Starting at the top, glue tabs on side body panels to front body panel.

Then, glue tabs on back body panel to each side body panel.

To close top and bottom of body, fold in tabs and glue in place.

Shrek is a registered trademark of DreamWorks Animation L.L.C.

Level: Medium

Score all the pieces: Using

a ruler as a guide, run the

back side of a butter knife

firmly along all dashed and

dotted lines.

Using scissors or a craft

knife and cutting mat, cut

out pieces along solid

lines. Don't forget to cut

slits on the body piece.

Tail: Insert (from non-printed side) into slit on back of body.

Glue tabs to inside of body.

Fold all pieces along

score lines, using the

folding key below as a

reference.

Mountain Fold

Valley Fold

Page 1 Then, glue tabs on back body panel to each side body panel. To close top and bottom of body, fold in tabs and glue in place. Shrek Forever After ™ & © 2010 DreamWorks Animation L.L.C. ©2010 Hewlett-Packard Company hp.com/create Shrek is a registered trademark of DreamWorks Animation L.L.C.
Page 2 Glue hat to top of head. Belt: Wrap around body (above the tail) and glue ends together. You’re done! Shrek Forever After ™ & © 2010 DreamWorks Animation L.L.C. ©2010 Hewlett-Packard Company hp.com/create Shrek is a registered trademark of DreamWorks Animation L.L.C.