Table of Contents
Advertisement
Declarations of Conformity and Regulatory Information
Manufacturer
Cisco Systems, Inc.170 West Tasman Drive, San Jose, CA 95134-1706 USA
Compliance
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates, uses,
and radiates radiofrequency energy, and if not installed and used according to the instructions, it may cause
harmful interference. Hence, professional installation is recommended. However, there is no guarantee that
interference will not occur. If this equipment does cause interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna
• Increase separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.This
device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection
of other channels is not possible.FCC regulations restrict the operation of this device to indoor use only. The
operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation
of this device is permitted in large aircraft while flying above 10,000 feet.Operation of transmitters in the
5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 44cm between the radiator and your body.
Hardware Installation Guide for Cisco Catalyst Wireless Gateways
26
Declarations of Conformity and Regulatory Information
Advertisement
Table of Contents
