Table of Contents
Advertisement
b. Apply molybdenum disulfide oil onto the
valve stem.
c. Install the valve into the cylinder head.
d. Turn the valve until the valve face and valve
seat are evenly polished, and then clean off
all of the lapping compound.
TIP
For the best lapping results, lightly tap the valve
seat while rotating the valve back and forth be-
tween your hands.
e. Apply a fine lapping compound to the valve
face and repeat the above steps.
f. After every lapping procedure, be sure to
clean off all of the lapping compound from the
valve face and valve seat.
g. Apply blue layout fluid "b" onto the valve face.
h. Install the valve into the cylinder head.
i. Press the valve through the valve guide and
onto the valve seat to make a clear impres-
sion.
VALVES AND VALVE SPRINGS
j. Measure the valve seat contact width again.
If the valve seat contact width is out of speci-
fication, reface and lap the valve seat.
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
EAS24310
CHECKING THE VALVE SPRINGS
The following procedure applies to all of the
valve springs.
1. Measure:
• Valve spring free length "a"
Out of specification → Replace the valve
spring.
Valve spring
Free length (intake)
38.10 mm (1.50 in)
Limit
36.10 mm (1.42 in)
Free length (exhaust)
38.10 mm (1.50 in)
Limit
36.10 mm (1.42 in)
Outer spring
Free length (intake)
36.93 mm (1.45 in)
Limit
35.00 mm (1.38 in)
Free length (exhaust)
36.93 mm (1.45 in)
Limit
35.00 mm (1.38 in)
2. Measure:
• Compressed valve spring force "a"
Out of specification → Replace the valve
spring.
5-22
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
Advertisement
Chapters
Table of Contents
Troubleshooting
