Table of Contents
Advertisement
Replacing a Switch Card
Figure 8: Switch Card Replacement
1
Loosen the thumb screws (2 each side of the chassis)
3
Disengage the lever (2)
Step 3
To install the module, follow these steps:
a) Make sure that each lever is in the fully open position.
b) Use both hands, one on the left side and one on the right side of the module, to support its weight.
c) Align the module with the open slot and gently slide the module into the slot until the lever's clamp touches the
chassis. Then engage the levers by pushing them toward the chassis until it clicks into place, reaching the fully closed
position..
Cisco Nexus 9408 NX-OS Mode Switch Hardware Installation Guide
38
2
Push the lever button (1 each lever)
Replacing Modules
Advertisement
Table of Contents
