Locat ion of cont rols
AMS
SHUF
DSPL
REPEAT
OFF
1 AM S (Automatic M usic Sensor) .
6 Reset button
button
7 Display w indow
2 AM S (Automatic M usic Sensor) >
8 SHUF (shuffle play) button
button
9 REPEAT (repeat play) button
3 Disc insertion slot
0 DSPL (display mode change) button
4 Z (eject) button
qa OFF button
5 u (play/ pause) button
If pressed during playback, the CD will
pause. If pressed again, playback will
continue.
Get t ing St art ed
Reset t ing t he unit
Before operating the unit for the first time or after replacing the car battery, you must reset the unit.
Press the reset button with a pointed object, such as a ball-point pen.
AMS
SHUF
DSPL
REPEAT
OFF
Reset button
Notes
• Pressing t he reset but t on w ill erase t he clock set t ing and some memorized program and memory f unct ions.
• When you connect t he pow er supply cord t o t he unit or reset t he unit , w ait f or about 10 seconds bef ore you
insert a disc. If you insert a disc w it hin t hese 10 seconds, t he unit w ill not be reset , and you w ill have t o press
t he reset but t on again.
Changing t he t ransm it t ing
Changing t he out put level
frequency
You can select the output level of the CD player.
Normally the initial output level is adequate;
Because this unit processes CD playback sound
change the level if necessary.
through an FM tuner, there may be interference
noise during CD playback. In this case, change
1
Press (REPEAT) for tw o seconds.
the frequency of the modulated RF signal
transmitted from the unit. The initial setting is
2
Press (REPEAT) again.
88.3 MHz.
1
Press (REPEAT) for tw o seconds until
frequency appears.
3
Press either the left or right side of (AMS)
2
to select the output level.
Press either the left or right side of (AMS)
to select the frequency.
To decrease the output level
Each time you press (AMS), the frequency
. : ,
changes as follows:
> : 88.3 MHz t 88.5 MHz t 88.7 MHz t
To increase the output level
88.9 MHz t 89.1 MHz t 89.3 MHz t
89.5 MHz t 89.7 MHz t 89.9 MHz t
> : ,
. : 88.3 MHz t 89.9 MHz t 89.7 MHz t
89.5 MHz t 89.3 MHz t 89.1 MHz t
88.9 MHz t88.7 MHz t 88.5 MHz t
4
Press (REPEAT) for more than tw o
seconds.
3
Press (REPEAT) for more than tw o seconds.
Note
Be sure t o set t he f requency of your FM t uner t o t he
new ly select ed f requency.
Downloaded from:
https://www.usersmanualguide.com/
Operat ion
Locat ing a specif ic t rack
List ening t o a CD
— Automatic M usic Sensor (AM S)
1
Adjust the selected transmitting frequency
w ith an FM tuner.
(88.3 MHz/88.5 MHz/88.7 MHz/88.9 MHz/
89.1 MHz/89.3 MHz/89.5 MHz/89.7 MHz/
89.9 MHz)
2
Insert a CD.
Playback starts automatically.
Locat ing a specif ic point in a t rack
Label side up
— M anual Search
If a CD is already inserted, press u to start
playback.
Note
Elapsed playing time
If "
you have reached t he beginning or t he end of t he
Note
disc and you cannot go any f urt her.
To play back an 8 cm (3 in.) CD, use t he opt ional
Sony compact disc single adapt er (CSA-8).
3
Adjust the volume w ith the volume
Playing a CD in various
control on the car audio.
m odes
To
Press
Playing t racks repeat edly
Stop playback
Z or (OFF)
— Repeat Play
Eject the CD
Z
Notes
• Be sure t o press (OFF) t o t urn t his unit of f w hen
When the current track is over, it will play again
you w ant t o list en t o FM radio.
from the beginning.
• When CD playback is st opped, you may hear some
noise f rom t he speakers. To prevent t his f rom
To return to normal playback mode, press again.
happening, t urn t he volume dow n bef ore st opping
CD playback.
Playing t racks in random order
• If you leave t he eject ed disc in t he disc insert ion
slot af t er you have pressed Z, t he disc w ill
— Shuffle Play
aut omat ically ret ract int o t he unit af t er about 15
seconds in order t o prot ect it .
To return to normal playback mode, press again.
Changing t he display it em
Each time you press (DSPL) during CD
playback, the item changes as follows:
Elapsed playing time b
B Track number
Initial setting
Troubleshoot ing guide
The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
Problem
Cause/Solut ion
CD cannot be loaded.
• Another CD is already loaded.
• The CD was forcibly inserted upside down.
Play does not begin.
Dirty disc.
CD is automatically ejected.
The ambient temperature exceeds 50°C (122°F).
CD w ill not eject.
Press the Z button for two seconds.
The operation buttons do not
Press the reset button.
function.
The sound skips due to
• The unit is installed at an angle of more than 60°.
• The unit is not installed in a sturdy part of the car.
vibration.
Error displays
The following indications will flash for about five seconds.
Display
Cause
A CD is dirty or inserted upside
down.
The CD player cannot be operated
because of some problem.
If the above-mentioned solutions do not help improve the situation, consult your nearest Sony dealer.
Addit ional Inform at ion
Precaut ions
During CD playback, press either side of
• This unit cannot be used with a car audio
(AMS) for each track you w ant to skip.
without an FM tuner.
AMS
• If your car was parked in direct sunlight
resulting in a considerable rise in temperature
inside the car, allow the unit to cool off before
operating it.
• If no power is being supplied to the unit,
To locate preceding
To locate succeeding
check the connections first. If everything is in
tracks
tracks
order, check the fuse.
•Connecting this unit may cause some car
battery wear when your car has no ACC
(accessory) position on the ignition key switch.
During playback, press and hold either
If you have any questions or problems
side of (AMS) for about tw o seconds.
concerning your unit that are not covered in this
Release w hen you have found the desired
manual, please consult your nearest Sony dealer.
point.
AMS
Not es on handling CDs
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc by its edge. To keep the
To search backw ard
To search forw ard
disc clean, do not touch the surface.
" or "
" appears in t he display,
Do not stick paper or tape on the labeled
surface.
Do not expose the discs to direct sunlight or heat
sources such as hot air-ducts, or leave them in a
Press (REPEAT) during playback.
car parked in direct sunlight where there can be
"REP" appears in the display.
a considerable rise in temperature inside the car.
Press (SHUF) during playback.
Before playing, clean the discs with a
"SHUF" appears in the display.
commercially available cleaning cloth. Wipe
each disc from the center out.
Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic
spray intended for analog discs.
Specificat ions
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
13 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
1 % total harmonic distortion.
Ot her specif icat ions
CD player sect ion
System
Compact disc digital audio
system
Signal-to-noise ratio
90 dB
Frequency response
10 – 20,000 Hz
Wow and flutter
Below measurable limit
Laser Diode Properties
Material
GaAs + GaAlAs
Wavelength
785 ~ 815 nm (Typ.800 nm)
Emission Duration
Continuous
Laser output power
Less than 0.5 mW*
* This out put is t he value measured at a dist ance of
Solut ion
0.7 mm f rom t he object ive lens surf ace on t he
Opt ical Pick-up Block.
Clean or insert the CD correctly.
Press the reset button or Z.
Not es on discs
If you use the discs explained below, the sticky
residue can cause the CD to stop spinning and
may cause malfunction or ruin your discs.
Do not use second-hand or rental CDs that have
a sticky residue on the surface (for example from
peeled-off stickers or from ink, or glue leaking
Compact Disc
from under the stickers.
There are paste residue
Ink is sticky
Player
Do not use rental CDs with old labels that are
beginning to peel off.
Stickers that are beginning
Operat ing Inst ruct ions
to peel aw ay, leaving a
sticky residue
Do not use your CDs with labels or stickers
attached.
Labels are attached
Not es on CD-R discs
•You can play CD-Rs (recordable CDs) on this
unit. However depending on the conditions of
the recording equipment or the CD-R disc
itself, some CD-Rs cannot be played on this
unit.
•You cannot play a CD-R that is not finalized
(Finalization is necessary for a recorded CD-R
Ow ner's Record
disc to be played on the audio CD player).
•You cannot play CD-RWs (rewritable CDs) on
The model and serial numbers are located on the bottom of the unit.
this player.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
When you play 8 cm (3 in.) CDs
product.
Use the optional Sony compact disc single
adapter (CSA-8) to protect the CD player from
Model No. CDX-1000RF Serial No.
damage.
Not es on m oist ure condensat ion
On a rainy day or in a very damp area, moisture
may condense on the lenses inside the CD
player. Should this occur, the unit will not
operate properly. In this case, remove the disc
CDX-1000RF
and wait for about an hour until the moisture
evaporates.
Sony Corporation © 2000
M aint enance
Fuse replacem ent
Warning
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
This equipment has been tested and found to
connection and replace the fuse. If the fuse
comply with the limits for a Class B digital
blows again after replacement, there may be an
device, pursuant to Part 15 of the FCC Rules.
internal malfunction. In such a case, consult
These limits are designed to provide reasonable
your nearest Sony dealer.
protection against harmful interference in a
residential installation. This equipment
Warning
generates, uses, and can radiate radio frequency
Never use a fuse with an amperage rating
energy and, if not installed and used in
exceeding the one supplied with the unit as this
accordance with the instructions, may cause
could damage the unit.
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/
TV technician for help.
General
You are cautioned that any changes or
modifications not expressly approved in this
Outputs
Line output
Power requirements
12 V DC car battery
manual could void your authority to operate
(negative ground)
this equipment.
Current drain
2 A (at disc loading)
Approx. 178 × 50 × 173 mm
Dimensions
× 2 × 6
(7
1
/
7
/
in.)
8
8
CAUTION
(w/h/d)
Approx. 182 × 53 × 159 mm
Mounting dimensions
The use of optical instruments with this product
1
× 2
1
× 6
3
(7
/
/
/
in.)
4
8
8
will increase eye hazard.
(w/h/d)
Mass
Approx. 1.1 kg (2 lb. 7 oz.)
Supplied accessories
Parts for installation and
connections (1 set)
Optional accessories
Compact disc single adapter
CSA-8
Rotary commander
RM-X4S
Source selector
XA-107
BUS cable (supplied with an
RCA pin cord)
RC-61 (1 m), RC-62 (2 m)
Design and specif icat ions are subject t o change
w it hout not ice.
3-045-044-11 (1)
Printed in Korea
Welcom e !
Thank you for purchasing the Sony Compact
Disc Player. This unit lets you enjoy a variety of
features.
Feat ures
•Easy connection to any car audio with an FM
tuner
•Dashboard installation for easy CD disc
changing
•8X digital sampling filter for clear CD audio
•Quick recovery function to minimize
disturbance from skips
•Repeat play function for playing tracks
repeatedly
•Shuffle play fucnion for playing tracks in
random order