Table of Contents
Advertisement
Installation Scenarios and Cabling Examples for Fast Ethernet Connections
Note
OL-12480-03
Get user manuals:
See SafeManuals.com
WAE appliances can be installed physically between two network devices (such as the branch office
router and branch office LAN switch) by connecting the WAE inline network adapter ports to the
network devices using the proper cables.
If you are connecting a WAE inline appliance between two devices using Gigabit Ethernet, you can use
either straight-through cables, crossover cables, or any combination of the two cable types, regardless of
the type of device. This section shows cabling examples for Fast Ethernet connections only, because Fast
Ethernet has specific cabling requirements.
The inline network adapter has four ports that are divided into two inline groups (see the
Indicators" section on page
paths, creating redundant WAN links. (See
Two WAEs with inline network adapters can also be installed back-to-back in a serial fashion between
two network devices for failover purposes. In this serial cluster configuration, if one WAE fails, the other
WAE can provide optimization. (See
When you connect two WAE inline appliances to each other serially, always use a crossover cable
between the two WAEs. (See
Figure 20
Cabling for a Single Inline WAE with Redundant WAN Connections
LAN switch
1
Connection: Management
Gigabit Ethernet: 1/0
Cable type: Straight-through (recommended)
3
Connection: WAE to LAN switch
(using InlineGroup 1/1)
Fast Ethernet: LAN1 (InlinePort 1/1/lan)
Cable type: Straight-through
5
Connection: WAE to WAN router B
(using InlineGroup 1/1)
Fast Ethernet: WAN1 (InlinePort 1/1/wan)
Cable type: Crossover
3). The WAE can be physically placed inline between two distinct network
Figure
20.)
Figure
21.)
Figure
22.)
1
MGMT
2
3
WAE
2
4
Installing the Cisco WAE Inline Network Adapter
WAN
4
Router A
5
WAN
Router B
Connection: WAE to LAN switch
(using InlineGroup 1/0)
Fast Ethernet: LAN0 (InlinePort 1/0/lan)
Cable type: Straight-through
Connection: WAE to WAN router A
(using InlineGroup 1/0)
Fast Ethernet: WAN0 (InlinePort 1/0/wan)
Cable type: Crossover
Cabling
"Ports and LED
29
Advertisement
Table of Contents
