Table of Contents
Advertisement
Installing Adapters in the FE-511, WAE-511, and WAE-611 Appliances
Step 10
Step 11
Step 12
Completing the Installation
Caution
Step 1
Caution
Step 2
Installing the Cisco WAE Inline Network Adapter
12
Get user manuals:
See SafeManuals.com
Reinstall the riser card. Make sure that the riser card is fully seated in the riser card connector (labeled
6 in
Figure
5) on the system board.
Tighten the captive screw for expansion slot 1.
Connect the required cables to the adapter.
To complete your installation, reinstall the cover and reconnect all cables that you disconnected earlier.
To maintain proper cooling and airflow, install the cover before turning on the appliance. Operating the
appliance for extended periods (over 30 minutes) with the cover removed might damage internal
components.
To install the cover, follow these steps:
Install the cover by placing it into position and sliding it forward, and then tighten the captive screws
(labeled 1 in
Figure
6).
Before sliding the cover forward, make sure that the cover will properly engage the ledge at the front of
the appliance.
Figure 6
Installing the Cover
Install the appliance in the rack.
1
OL-12480-03
Advertisement
Table of Contents
