Page 2
Assemblers and other persons who are not employed by or otherwise directly affiliated with or autho- rized by Siemens or one of its affiliates are directed to contact one of the local offices of Siemens or one of its affiliates before attempting installation or service procedures.
P16 ......... . . 7 - 1 8 _______Changes to previous version _____________________________________ 8 - 1 Siemens-Elema AB SPR8-220.091.01 Page 3 of 4 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD...
Page 4
0 - 4 Contents This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 4 of 4 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...
65 28 306. When replacing the old type with the new one, the existing software has to be replaced by V0.8H (part no. 65 86 114). It is also necessary to equip the MOBILETT Plus HP with two extra capacitors. To make room for the capacitors, the battery boxes and battery shelves must be replaced too.
The capacitors in M10 must be considered charged until the pro- tective measures listed in the document Service Instructions have been performed. CAUTION Be sure to follow the ESD guidelines. MOBILETT Plus HP SPR8-220.091.01 Page 2 of 2 Siemens-Elema AB Service Rev.
Replace battery boxes Unplug all KBATT plugs (1/Fig. 1). Remove the screws (2/Fig. 1) and pull out the four battery boxes. Fig. 1 Siemens-Elema AB SPR8-220.091.01 Page 1 of 6 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD Service...
Page 8
Very high energy is stored in the batteries. Life-threatening electric shock hazard exists. Replace the old battery boxes. Fasten the old top covers and tighten the holding belts. Fig. 3 MOBILETT Plus HP SPR8-220.091.01 Page 2 of 6 Siemens-Elema AB Service Rev.
Pull out the power conversion unit, see chapter with same name in the document Service Instructions. Fig. 4 Disconnect cable (1/Fig. 4) from P24 and P14 on the power conversion unit. Siemens-Elema AB SPR8-220.091.01 Page 3 of 6 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD Service...
(3/Fig. 5) from the connector (4/Fig. 5). BLACK Fig. 5 Remove the upper and lower battery shelves from the MOBILETT Plus HP by loosen four screws on each side. Move the fuse (5/Fig. 5), connector (4/Fig. 5) and battery connector (KBATT) (6/Fig.
Inform the customer of the change if applicable. Insert the supplements for each technical document attached in this document into the Technical Manual for the Mobilett Plus product affected. Siemens-Elema AB SPR8-220.091.01 Page 5 of 6 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD Service...
Page 12
2 - 6 Replacing the Inverter This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 6 of 6 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...
The magnetization in the stator and rotor winding produces an eddy current field which slows down the speed of the rotor. The brake time to a full stop takes 9 s. Siemens-Elema AB SPR8-220.091.01 Page 1 of 2 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD...
Page 14
3 - 2 Supplement to Functional Description This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 2 of 2 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...
If an error is determined during any of the tests, the current program stops and the follow- ing message appears: Err xx = Test results are "not valid." Siemens-Elema AB SPR8-220.091.01 Page 1 of 2 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD Service...
Page 16
4 - 2 Supplement to Maintenance Instructions This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 2 of 2 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...
The service programs P05 (Automatic maintenance test), P12 (Inverter and single tank test) and P13 (Inverter test) are removed. • Only for MOBILETT Plus HP - The service program P11 (Backup battery test) is removed. List of test programs available in service mode...
Page 18
5 - 2 Supplement to Service Instructions This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 2 of 2 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...
Appendix 7 - 1 Appearance number Message history Total amount of exposures....................Siemens-Elema AB SPR8-220.091.01 Page 1 of 2 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD Service...
Page 22
7 - 2 Appendix This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 2 of 2 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...
Page 23
Page Change Chapter completely revised. New software version with new article number implemented. Article number of this document is changed. New step 3. Siemens-Elema AB SPR8-220.091.01 Page 1 of 2 MOBILETT Plus HP Solna, Sweden Rev. 03 03.03 SPS-UD Service...
Page 24
8 - 2 Changes to previous version This page intentionally left blank. MOBILETT Plus HP SPR8-220.091.01 Page 2 of 2 Siemens-Elema AB Service Rev. 03 03.03 SPS-UD Solna, Sweden...