Table of Contents
Advertisement
12
www.aeg.com
7.3 Labels supplied with the
accessories bag
Stick the adhesive labels as indicated
below:
A
MOD.
PROD.NO.
SER.NO
DATA
A. Stick it on Guarantee Card and send
this part (if applicable).
B. Stick it on Guarantee Card and keep
this part (if applicable).
8. INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
8.2 Important safety
requirements
This hob must be installed in accordance
with the Gas Safety (Installation and Use)
Regulations (Current Edition) and the IEE
Wiring Regulations (Current Edition).
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
C
MOD.
PROD.NO.
SER.NO.
0049
C. Stick it on instruction booklet.
For appliances installed in the Republic
of Ireland please refer to NSAI- Domestic
Gas Installation I.S. 813 Current Editions
and the ETCI Rules for Electrical
Installations.
Provision for ventilation
Detailed recommendations are
contained in the following British
Standards Codes Of Practice: B.S. 6172/
B.S. 5440, Par. 2 and B.S. 6891 Current
Editions.
The hob should not be installed in a bed
sitting room with a volume of less than
20 m³. If it is installed in a room of
volume less than 5 m³ an air vent of
effective area of 100 cm² is required. If it
is installed in a room of volume between
5 m³ and 10 m³ an air vent of effective
area of 50 cm² is required, while if the
volume exceeds 11 m³ no air vent is
required.
TYPE
IP20
Advertisement
Table of Contents
