Connecting To The Switch Ports - Cisco ME 3400E Getting Started Manual
Cisco systems ethernet access switch getting started guide
Hide thumbs
Also See for ME 3400E:
- Hardware installation manual (100 pages) ,
- Quick start manual (4 pages) ,
- System message manual (106 pages)
Table of Contents
Advertisement
6
Connecting to the Switch Ports
This section describes how to connect to the fixed switch ports and to the SFP module ports. The switch in the illustrations
might be different from your switch, but the instructions apply to all Cisco ME 3400E switches.
Connect to 10/100 or 10/100/1000 Ports
When you connect to servers, workstations,
Step 1
customer-premises equipment (CPE), wireless access points,
and routers, insert a straight-through, twisted four-pair,
Category 5 cable in a switch 10/100 or 10/100/1000 port.
Use a crossover, twisted four-pair, Category 5 cable when you
connect to other switches, hubs, or repeaters.
Insert the other end of the cable into a connector on the other device.
Step 2
The automatic medium-dependent interface crossover (auto-MDIX) feature is enabled by default. The switch detects
Note
the required cable type for copper Ethernet connections and configures the interfaces accordingly. You can use either a
crossover or a straight-through cable for connections to a copper 10/100, 10/100/1000, or 1000BASE-T SFP module
port on the switch, regardless of the type of device on the other end of the connection.
Install the SFP Modules and Connect to the Ports
To prevent damage to the SFP module, make sure that you verify the proper orientation of the module by consulting
Caution
the module documentation before you install it.
Grasp the SFP module on the sides, and insert it into the switch slot
Step 1
until you feel the connector snap into place.
Step 2
Insert an appropriate cable into the SFP module port. Insert the
other cable end into the other device.
12
Hide quick links:
Advertisement
Table of Contents
