Installing Sfp Modules - Cisco ME 3400 Hardware Installation Manual
Cisco systems ethernet access switch installation guide
Hide thumbs
Also See for Cisco ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (950 pages) ,
- Getting started manual (33 pages)
Table of Contents
Advertisement
Chapter 2
Switch Installation
Installing SFP Modules
Figure 2-12
We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached
Caution
because of the potential damage to the cables, the cable connector, or the optical interfaces in the SFP
module. Disconnect all cables before removing or installing an SFP module.
Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP
modules more often than is absolutely necessary.
Figure 2-12
To insert an SFP module into the module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 1
Some SFP modules identify the top side of the module with send (TX) and receive (RX) markings or
arrows that show the direction of the connection.
If the SFP module that you are using has the markings, use them to identify the top side of the module.
Step 2
Step 3
Align the SFP module in front of the slot opening.
Step 4
Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear
of the slot (see
Figure 2-13
OL-7677-04
shows an SFP module that has a bale-clasp latch.
SFP Module with a Bale-Clasp Latch
Figure
2-13).
Installing an SFP Module into an SFP Module Slot
C is co M
E 3 4 0 0
1
2
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
SE RI ES
Installing and Removing SFP Modules
2-17
Hide quick links:
Advertisement
Table of Contents
