hit counter script

Cisco ME 3400 Hardware Installation Manual page 27

Cisco systems ethernet access switch installation guide
Hide thumbs Also See for Cisco ME 3400:
Table of Contents

Advertisement

Chapter 2
Switch Installation
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Warning statement 1030 applies to all switches except the Cisco ME 3400G-2CS switch:
Note
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet Statement 1044
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. Statement 1045
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of:
122°F (50°C) Statement 1047
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Caution
To comply with the Telcordia GR-1089 Network Equipment Building Systems (NEBS) standard for
electromagnetic compatibility and safety, connect the Ethernet cables only to intrabuilding or
nonexposed wiring or cabling.
OL-7677-04
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
Preparing for Installation
2-3

Advertisement

Table of Contents
loading

Table of Contents

Save PDF