Completing The Express Setup Fields - Cisco Catalyst 3020 Getting Started Manual
Cisco catalyst blade switch 3020 for hp
Hide thumbs
Also See for Catalyst 3020:
- Command reference manual (744 pages) ,
- Configuration manual (712 pages) ,
- Release note (54 pages)
Table of Contents
Advertisement
The Express Setup page appears.
Go to "Completing the Express Setup Fields" section on page 17 to finish setting up the switch
Step 8
module using the Express Setup screen of the Device Manager.
Completing the Express Setup Fields
Follow these steps to finish setting up the switch module:
Enter this information in the Network Settings fields:
Step 1
In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only if
–
you want to change the management interface through which you manage the switch module
and to which you assign IP information. The VLAN ID range is 1 to 1001.
In the IP Address field, enter the IP address of the switch module. In the IP Subnet Mask field,
–
click the drop-down arrow, and select an IP Subnet Mask.
In the Default Gateway field, enter the IP address for the default gateway (router).
–
Enter your password in the Switch Password field. The password can be from 1 to 25
–
alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,
but does not allow spaces at the beginning or end. In the Confirm Switch Password field, enter
your password again.
17
Advertisement
Table of Contents
