Statement 2007-Emc Environmental Conditions For Products Installed In The European Union; European Union (Eu) Compliance; Statement 2020-Class A Warning Notice - Cisco uBR7200 Regulatory Compliance And Safety Information Manual
Cisco systems universal broadband router regulatory compliance and safety information
Table of Contents
Advertisement
Statement 2007—EMC Environmental Conditions for Products Installed in the European Union
Statement 2007—EMC Environmental Conditions for Products
Installed in the European Union
This section applies to products to be installed in the European Economic Union.
The equipment is intended to operate under the following environmental conditions with respect
to EMC:
•
•
•
In addition, if equipment is operated in a domestic environment, radio-frequency interference may occur.
Note
European Union (EU) Compliance
This Apparatus complies with EN55022 Class A and EN55024 standards when used as ITE/TTE
equipment and EN 300 386 for Telecommunications Network Equipment (TNE).
Statement 2020—Class A Warning Notice
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Statement 340—Class A Warning for CISPR22
Warning
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Waarschuwing
Dit is een product van klasse A. In een woonomgeving kan dit product radiostoring veroorzaken. In
dat geval moet de gebruiker de juiste maatregelen nemen.
Varoitus
Tämä on A-luokan tuote. Kotona käytettynä tämä tuote voi aiheuttaa radiotaajuushäiriöitä, jolloin
käyttäjän tulisi ryhtyä vaadittaviin toimenpiteisiin häiriöiden ehkäisemiseksi.
Regulatory Compliance and Safety Information for the Cisco uBR7200 Series Universal Broadband Routers
78
A separate, defined location that is under user's control.
As a minimum, earthing and bonding shall meet the requirements of ETS 300 253:1995 or
CCITT K27:1996.
AC power distribution inside the building shall be, as a minimum, one of the following types (as
defined in IEC 60364-3:1993):
TN-S
–
TN-C
–
TT
–
IT
–
78-14140-08
Advertisement
Table of Contents
