Install The Fips Opacity Shield In A Two-Post Rack - Cisco Firepower 1100 Series Hardware Installation Manual
Hide thumbs
Also See for Firepower 1100 Series:
- Hardware installation manual (30 pages) ,
- Installation manual (44 pages) ,
- Hardware installation manual (42 pages)
Table of Contents
Advertisement
Install the FIPS Opacity Shield in a Two-Post Rack
Figure 26: Remove and Install an SSD
Step 3
Tighten the thumb screws on both sides of the SSD bay.
Step 4
Check the SSD LED to make sure the SSD is seated properly and functioning. See
description of the SSD LED.
Install the FIPS Opacity Shield in a Two-Post Rack
Note
Before you begin
Caution
You need the following items to install the FIPS opacity shield:
• #1 Phillips screwdriver
• The following items from the FIPS kit (part number 800-105495-01):
Cisco Firepower 1100 Series Hardware Installation Guide
34
Because the FIPS opacity shield covers the serial number on the chassis, the CO should copy the serial number
and store it in a secure place. The serial number is needed when you call Cisco TAC.
This procedure should be performed only by the Crypto Officer (CO).
Installation, Maintenance, and Upgrade
Rear Panel LEDs, on page 9
for a
Advertisement
Table of Contents
