Table of Contents
Advertisement
Power switch
1
2
Handle
Plug the power cable into the AC connector of the power supply.
Step 2
For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon cable tie
Note
through the hole in the handle and around the cable.
Plug the AC power supply cable into the AC power source. Repeat
Step 3
if required.
Turn on the power switch on the router.
Step 4
6
Cabling
This section contains information about connecting interface card cables, auxiliary, and console ports.
Connecting Interface Card Cables
The instructions for connecting the cables for each cable interface line card installed in the Cisco uBR7225 router are contained
in the cable interface card installation document. Refer to the Cisco uBR7200 Series Cable Interface Line Card Hardware
Installation Guide at the following URL:
http://www.cisco.com/en/US/products/hw/cable/ps2217/prod_installation_guides_list.html
Console and Auxiliary Port Connection Equipment
The console port is a DCE DB-25 receptacle for connecting a data terminal, which you use to configure the interfaces and bring
up the Cisco uBR7255VXR router. The auxiliary port is a DTE DB-25 plug for connecting a modem or the other DCE device
(such as a channel service unit/data service unit) to the router.
Both the console and auxiliary ports are asynchronous serial ports; any devices connected to these ports must be capable
Note
of asynchronous transmission.
Before connecting a terminal to the console port, configure the terminal to match the router console port as follows:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit (9600 8N1)
For details about cabling, refer to the Cisco uBR 7200 Series Universal Broadband Router Hardware Installation Guide at the
following URL:
http://www.cisco.com/en/US/products/hw/cable/ps2217/prod_installation_guides_list.html
AC-input receptacle
3
4
Captive installation screw
Step 1
through
Step 3
for the second power supply,
15
Advertisement
Table of Contents
