Remove And Then Replace An Ac Power Supply - Cisco Router ASR 1006 Hardware Installation Manual

Cisco systems router quick start guide

Hide thumbs Also See for Router Cisco ASR 1006:

Hardware installation manual (188 pages)

Deployment manual (40 pages)

Software configuration manual (462 pages)

Table Of Contents

Table of Contents

Replace a Power Supply in a Cisco ASR 1006 Router, page 37

•

• Install and Remove the Shared Port Adapter, page 41

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Powering Off the Cisco ASR 1006 Router Safely

This section explains how to shut down the Cisco ASR 1006 Router. It is recommended that before turning off all power to the

chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload

operation is complete, then the Cisco ASR 1006 Router can be powered off safely.

To remove power from a Cisco ASR 1006 Router safely, follow this procedure and see the examples:

Slip on the ESD-preventative wrist strap that was included in the accessory kit.

Step 1

Step 2

Enter the reload command.

Confirm the reload command:

Step 3

Rmcp-6ru-1#reload

Proceed with reload? [confirm]

Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis

code

After confirming the reload command, wait until the system bootstrap message displays before powering off the system.

Step 4

System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)

Technical Support: tap://www.cisco.com/techsupport

Current image running: Boot ROM0

Last reset cause: LocalSoft

ASR1000-RP1 platform with 4194303 Kbytes of main memory

mcp-6ru-1-rp0-rommon 1>

Remove any power cables from the Cisco ASR 1006 Router.

Step 5

a. For power supplies with a circuit breaker switch, position the switch to the Off (O) position.

b. For power supplies with a standby switch, place the standby switch in the Standby position.

After powering off the router, wait a minimum of 30 seconds before powering it on again.

Note

Replace a Power Supply in a Cisco ASR 1006 Router

This section provides instructions for removing and replacing the AC power supply and the DC power supply in a Cisco

ASR 1006 Router. Before you begin, make certain the chassis is grounded.