Table of Contents
Advertisement
Installing WICs and VICs
Before opening the chassis, disconnect the telephone-network
Warning
cables (from the card) to avoid contact with the
telephone-network voltages.
Do not work on the system or connect or disconnect cables during
Warning
periods of lightning activity.
Do not connect a WAN, telephone or fax cable to the card until you
Caution
have completed the installation procedure.
Follow these steps to remove and insert a card in the router:
Make sure the router is turned off and is disconnected from the power supply.
Step 1
Loosen the thumbscrews on the WIC or VIC slot cover on the rear panel, as shown
Step 2
in Figure 2.
You should be able to loosen the screws using your fingers; however, if the screws
are very tight, you might need to use a Phillips screwdriver.
Cisco 1750 Router Hardware Installation Guide
vi
78-6169-02
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco CISCO1750
Related Products for Cisco CISCO1750
- Cisco CISCO1921-SEC/K9
- Cisco CISCO1602-CH - 1602 Router - EN
- Cisco CISCO1602-R-RF - 1602 Router - EN
- Cisco CISCO1603-RF - 1603 Bridge/router
- Cisco CISCO1604-R - 1604 Router
- Cisco CISCO1701-K9-RF - 1701 ADSL Security Access Router
- Cisco CISCO1805-D - 1805 Integrated Services Router
- Cisco CISCO1812/K9-RF - Rf 1812 Ethernet Router