hit counter script

Cisco CISCO10720 Installation And Configuration Manual page 37

Internet router uplink cards installation and configuration
Table of Contents

Advertisement

Chapter 3
Installing and Removing the Uplink Cards
It is not necessary to remove the cable-management tray in order to install or remove an uplink card.
Note
Only the cable-management cover must be removed in order to install or remove an uplink card.
If the cable-management cover is not installed, go to the
page
3-2.
Perform the following steps to remove the cable-management cover:
Figure 3-4
Verify that all cables are safely secured before detaching the cable-management cover.
Step 1
Use a Number 1 Phillips screwdriver to loosen and unscrew the captive installation screws holding the
Step 2
cable-management cover to the router.
Remove the cable-management cover from the router. (See
Step 3
Figure 3-5
To avoid accidental damage to router cables or card ports, remove all cables before removing the
Caution
cable-management tray.
Use a Number 1 Phillips screwdriver to remove the screws holding the cable-management tray to the
Step 1
router. (See
Lift the cable-management tray from the router.
Step 2
78-13113-06 B0
Removing the Cable-Management Cover
C IS C O
1 0 7 2 0 IN
T E R N E
Removing the Cable-Management Tray
Figure
3-5.)
"Powering Down the Router" section on
RE SE T
CO NS
OL E AU
AC OK
X
DC OK
OT F
AC OK
DC OK
OT F
DON NOT
REM OVE
OR INS
ERT CAB
WIT H THE
LES
POW ER
ON
INP UT 100
-20 0- 50/
60H z 2-5
T R O U T
E R
Figure
RE SE T
CO NS
OL E AU
AC OK
X
DC OK
OT F
AC OK
DC OK
OT F
DO N NO
T RE MO
OR INS
VE
ER T CA
WIT H TH
BLE S
E PO WE
R ON
INP UT 10
0-2 00 - 50
/60 Hz 2-5
A
Removing the Cable-Management System
A
3-4.)
Book Title
3-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

10720

Table of Contents

Save PDF