Table of Contents
Advertisement
Installing Components Using the Graphical User Interface
Installing Extensions
Before you install the Network Registrar extensions, complete the steps described in the
and Startup Process" section on page
Step 1
On the Installation Components screen, select the Cisco Network Registrar extension points option, then
click Next to continue; the Home Directory Destination screen appears.
Note
Enter the pathname for the home directory, or click the Browse button to locate the desired directory.
Step 2
Note
Click Next. The installation program performs some validation and, prompts you to create the directory,
Step 3
if necessary, before the Data Directory Destination screen appears.
Accept the default directory or enter a new directory. You can use the Browse button to select a new
Step 4
directory.
Note
Click Next. The Regional Distribution Unit Host/Port screen appears.
Step 5
Step 6
Enter the IP address (or hostname) and the listening port of the host where the RDU software is installed.
By default, the name of the local host appears in the RDU IP Address field. The RDU uses the listening
port to communicate with the DPEs and Network Registrar extension points.
Click Next. The Cisco Network Registrar Extension Point Provisioning Group screen appears.
Step 7
Enter the name of the extension point provisioning group.
Step 8
Click Next. The PacketCable Panel screen appears.
Step 9
Step 10
Determine if you need to install the voice technology option and click:
•
•
Enter the appropriate information into the fields shown.
Step 11
Cisco Broadband Access Center for Cable Installation Guide 2.7
3-4
The installation program now validates your Network Registrar (CNR) installation. We
recommend that you have CNR version 6.1.2.3 or higher. If the required version is not installed,
the installation process is terminated and you must upgrade to the required Network Registrar
version before proceeding.
The installation program does not ask for the home directory when it identifies that you are
installing BACC components on a computer that already has a BACC component installed on it.
By default, the installation program installs the data directory (BPR_DATA) on a different
directory than the home directory (BPR_HOME). Cisco Systems recommends that the data
directory be on a different physical disk than the home directory; for example,
/var/disk0/CSCObpr. However, you can install the data directory on the same disk as the home
directory.
Yes button if you want to install the voice technology option. The PacketCable Properties screen
appears.
No if you do not have a valid license key for this technology. After clicking No, go to step
number 12.
2-2. To install the extensions:
Chapter 3
Installing Components
"Installation
OL-19105-01
Advertisement
Table of Contents
