Removing Sfp Modules - Cisco 3800 Series Quick Start Manual
Systems routers
Hide thumbs
Also See for 3800 Series:
- Quick start manual (40 pages) ,
- User manual (7 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Removing SFP Modules
Follow these steps to remove an SFP from a Cisco 3800 series router:
Disconnect all cables from the SFP.
Step 1
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable
Warning
is connected, avoid exposure to laser radiation and do not stare into open apertures.
The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do
Caution
not pull on the cabling in an attempt to remove the SFP.
Disconnect the SFP latch. See
Step 2
SFP modules use various latch designs to secure the module in the SFP port. Latch designs are not linked
Note
to SFP model or technology type. For information on the SFP technology type and model, see the label
on the side of the SFP.
Figure 45
A
1
2
Use a pen, screwdriver, or other small straight tool to gently release a bale-clasp handle if you cannot
Tip
reach it with your fingers.
Grasp the SFP on both sides and remove it from the router.
Step 3
OL-5968-01
Disconnecting SFP Latch Mechanisms
1
B
Sliding latch
Swing and slide latch
Figure
45.
2
3
Bale-clasp latch
4
Plastic collar latch
Installing SFP Modules in Cisco 3800 Series Routers
Removing SFP Modules
3
4
71
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
