Cisco 7200 VXR Product Overview page 3
Cisco router owner manual
Hide thumbs
Also See for 7200 VXR:
- User manual (178 pages) ,
- Quick start manual (48 pages) ,
- Manual (14 pages)
Table of Contents
Advertisement
Chapter 1
Cisco 7200 VXR Product Overview
See
Table 1-1
Physical Specifications
Description
Specification
Midplane
Two primary PCI buses, and one secondary PCI bus
Three primary PCI buses—With the NPE-G2 or NPE-G1 installed, no I/O controller, and the Port
Adapter Jacket Card installed, three PCI buses are available. Aggregate bandwidth of the PCI buses
is 900 Mbps. The third PCI bus goes to the Port Adapter Jacket Card and provides unlimited
bandwidth for one port adapter.
Dimensions
5.25 in. x 16.8 in. x 17 in. (13.34 cm x 42.67 cm x 43.18 cm)
(H x W x D)
Weight
Chassis fully configured with a network processing engine or network services engine, I/O
controller, maximum number of port adapters, 2 power supplies, and a fan tray: ~ 50 lb (22.7 kg)
Heat dissipation
370W (1262 BTU
Chassis fan noise
Tested:
levels—single speed
fan
Maximum: 65 dBa
Airflow
~80 cfm
Temperature
32 to 104 F (0 to 40 C) operating; –4 to 149 F (–20 to 65 C) nonoperating
Humidity
10 to 90% noncondensing
Power Specifications
AC-input voltage rating 100–240 VAC
AC-input current rating 5A
AC-input frequency
50/60 Hz
rating
AC-input cable
18 AWG
country-dependent plug on the power source end
DC-output power
280W maximum (with either a single or dual power supply configuration)
DC-input voltage rating –48 VDC
–60 VDC nominal in the European Community
OL-5013-08
Table 1-1
for the Cisco 7200 VXR physical specifications and power requirements:
With an NPE-G2 or NPE-G1 and an I/O controller installed, the I/O controller does not use
•
bandwidth points, and the NPE-G2 or NPE-G1 does use bandwidth points. The NPE-G2 or
NPE-G1 does not use bandwidth points if installed without the I/O controller.
•
With an NSE-1, NPE-400, or NPE-300 installed: aggregate bandwidth of 900 Mbps
•
With n NPE-100, NPE-150, or NPE-200 installed: aggregate bandwidth of 600 Mbps
2
)
Front (I/O controller and port adapter side) 44.2 dB
•
Back (power supply side) 43.7 dB
•
Left (fan side) 47.2 dB
•
Right 44.8 dB
•
3
4
wide input with power factor correction
5
at 100–240 VAC with the chassis fully configured
6
7
three-wire cable, with a three-lead IEC-320 receptacle on the power supply end, and a
8
nominal in North America
Cisco 7200 VXR Installation and Configuration Guide
Physical Description
1
1-3
Advertisement
Table of Contents
