hit counter script
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Network Router
  5. 1760 - VPN Bundle Router
  6. Quick start manual

Cisco 1760 Quick Start Manual page 18

Modular access router cabling and installation
Hide thumbs Also See for 1760:
Table of Contents

Advertisement

Table 2
West Router Telephone Numbers and Voice Ports
Telephone Number
Voice Port
408 555-3737
0/0
408 555-4141
0/1
If your router is configured with four 2-port VICs, you can connect a total of eight telephones and fax machines to it.
Note
As the router has only four slots, you need to replace one VIC with a WIC to provide an interface for IP connectivity
to the WAN and for data traffic. To accommodate more voice devices, you need to add more routers or use an E&M
VIC and a local PBX, rather than connecting every telephone to its own FXS VIC.
Local Dial Peers
To route a received voice call to the right destination, the router needs to know which telephone number belongs to each voice
port. For instance, if a call comes in for 408 555-3737, the router needs to know that this telephone is connected to voice port
0/0 (as shown in Figure 12). In other words, the router needs to know the information in Table 2.
To hold this information, Cisco IOS software uses objects called dial peers. A telephone number, a voice port, and other call
parameters are tied together by associating them all with the same dial peer. Configuring dial peers is similar to configuring
static IP routes—you are telling the router what path to follow to route the call. All voice technologies use dial peers to define
the characteristics associated with a call leg. A call leg is a segment of a call path, for instance, between a telephone and a router,
a router and a network, a router and a PBX, or a router and the PSTN. Each call leg corresponds to a dial peer.
Dial peers are identified by numbers, but they are usually referred to as tags to avoid confusion with telephone numbers.
Dial-peer tags are arbitrary integers that can range from 1 to 2
any dial-peer tag that is convenient or that makes sense to you. Dial peers on the same router must have unique tags, but you
can reuse the tags on other routers.
Table 3 assigns a dial-peer tag to each telephone number and its associated voice port on the West router. This type of dial peer
is called a POTS dial peer or a local dial peer. The term POTS (plain old telephone service) means that the dial peer associates
a physical voice port with a local telephone device. (Voice over IP, or VoIP, dial peers are explained in the "Calling Between
Routers" section on page 20.)
Table 3
West Router Local Dial Peers
Telephone Number
Voice Port
408 555-3737
0/0
408 555-4141
0/1
You should construct a table similar to Table 3 for your own routers, assigning your own telephone numbers and dial-peer tags.
The telephone numbers used in this guide are only examples and are invalid for public use in the United States. When
Note
you configure your network, be sure to substitute your own telephone numbers.
To configure the router with the dial-peer information in Table 3, enter the following global configuration commands:
West> enable
Password:
West# configure terminal
West(config)# dial-peer voice 401 pots
West(config-dial-peer)# destination-pattern 14085553737
West(config-dial-peer)# port 0/0
West(config)# dial-peer voice 402 pots
West(config-dial-peer)# destination-pattern 14085554141
West(config-dial-peer)# port 0/1
West(config-dial-peer)# exit
18
31
Dial-Peer Tag
401
402
– 1 (2147483647). Within the allowed range, you can choose

Advertisement

Table of Contents
loading

Related Manuals for Cisco 1760

Related Products for Cisco 1760

Table of Contents

Save PDF