Cisco 12012 Replacement Instructions Manual page 13

Gigabit switch router card cage assembly

Hide thumbs Also See for 12012:

Table of Contents

Proceeding from left to right in the upper card cage, select a line card. Starting with the

Step 3

bottom port on the line card, disconnect the network interface cable from the bottom port

on the line card. (Refer to Figure 5a.)

Carefully remove the interface cable from the vertical cable-management bracket clips.

Step 4

(Refer to Figure 5b.)

Carefully remove the interface cable from the vertical cable-management bracket clip

Step 5

nearest the line card port. (Refer to Figure 5c.)

Figure 5

Removing the Interface Cables From a Line Card

Chassis

cable-management

tray

Line card

cable-management

bracket

Interface

cable

Carefully remove the interface cable from the horizontal cable-management tray and set

Step 6

the interface cable aside.

Repeat Step 3 through Step 6 for rest of the interface cables on that line card, then proceed to the

next line card in the upper card cage. Continue the procedure until you have disconnected and

removed all the line card interface cables from the cable-management system. Do not remove the

vertical cable-management bracket from the line card.

Cisco 12012 Gigabit Switch Router Card Cage Assembly Replacement Instructions

Removing and Replacing a Card Cage Assembly

Cable clip Cable clips

Table of Contents

Gsr12-cardcage